The transverse magneto-optical Kerr effect (TMOKE) in magnetite-based magnetoplasmonic crystals is studied experimentally and theoretically. We analyze angle-resolved TMOKE spectra from two types of structures where noble metallic stripes are incorporated inside a thin magnetite film or located on top of a homogeneous film. A multiple-wide-band enhancement of the TMOKE signal in transmission is demonstrated. The complex dielectric permittivity and gyration are experimentally determined using the ellipsometry technique as well as Faraday rotation and ellipticity measurements. The obtained parameters are used in rigorous coupled-wave analysis (RCWA) calculations for studying the optical resonances. Our RCWA calculations of transmittance and TMOKE are in good agreement with the experimental data. The role of guiding and plasmonic modes in the TMOKE enhancement is revealed. We demonstrate that the TMOKE provides rich information about the studied optical resonances.
Photonic bound states in the continuum (BIСs) were investigated depending on material and radiation losses on the example of the phase-change chalcogenide and two types of resonators in the form of a cylinder and a ring which support quasi-BIC according to the Friedrich-Wintgen mechanism. The complex refractive index for the amorphous and crystalline phases of was measured experimentally. It was found that as the material losses increase, the quasi-BIC becomes practically a dark mode, while the usual resonator eigenmodes continue to remain intense. At the same time the strength of the mode coupling has been not affected, that is, the Rabi splitting remains unchanged in the studied range of losses. Photonic mode switching during the amorphous-crystalline phase transition was also investigated and two mechanisms were identified, including an efficient Fano resonance mechanism that can be used in real devices.
Metasurfaces based on phase change materials are widely used for the controllable on-demand modification of properties of a device at the postfabrication stage. We report the fabrication of a switchable Ge-Sb-Te (GST)-based metasurface with a submicron period by magnetron sputtering with electron beam lithography postprocessing. We provide theoretical and experimentally measured angle-resolved reflection spectra of such metasurfaces. In these spectra, we observe magnetic dipole resonance features, which significantly differ for two different GST states, and Rayleigh anomalies, whose spectral position remains unchanged during the phase transition. We demonstrate the optical response of these metasurfaces to be strongly modulated under GST phase transition in the telecom wavelength range.
A bound state in the continuum (BIC) is a concept of a wave phenomenon that remains confined even though it coexists with a continuous radiative spectrum. In photonics, such states are promising for the enhancement of the light-matter interaction. In this work, we study the optical properties of the :H-based planar waveguide structure covered by a two-dimensional array of gold nanodisks. To obtain BICs, we use a square lattice of nanodisks, which has one of the highest degrees of symmetry. The lattice provides light coupling to both TE and TM guided modes, while the single nanodisk supports localized plasmon resonance. We show that the structure possesses different types of BICs which are the result of the interaction of guided modes and single-particle resonances.
9 December 2025 in The Journal of Chemical Physics
The terahertz frequency range has attracted significant interest for its potential in applications such as high-speed communication, sensing, and imaging. However, the dynamic control of terahertz waves remains a challenge. Here, we present a switchable metasurface incorporating the Ge–Sb–Te (GST) phase-change material, designed to achieve switchable electromagnetically induced transparency (EIT) in the terahertz frequency range. The metasurface features an array of gold stripes on a thin GST sublayer, with the quasi-BIC-related EIT mode arising from a hybrid symmetry-protected Friedrich–Wintgen supercavity mode. By carefully adjusting the geometric parameters of the gold stripes, the EIT bandwidth can be precisely tuned through the controlled asymmetry. The phase transition of GST induces a significant change in the metasurface electrical properties, enabling robust nonvolatile switching between transparent and opaque states of the device. Both theoretical analysis and experimental validation confirm the efficacy of this design for dynamic modulation in the terahertz regime, demonstrating its potential for advanced terahertz photonic applications.