13 March 2023 in IEEE Transactions on Circuits and Systems II: Express Briefs
This brief presents a compact (5mm×56mm) and ultra-wideband directional coupler fabricated by copper additive manufacturing. The coupler is directly synthesized through the even/odd mode extraction algorithm and realized from a pair of coupled air-filled rectangular coaxial lines with working frequency of 0.22-26.5GHz (usable to 10MHz). Periodically loaded polymer strips are embedded with the air-filled coaxial lines to support the inner conductor but this strips also deteriorate the directivity of the coupler. To alleviate this, a special arrangement of the polymer strips is proposed to decrease the unwanted coupling through the strips. As an example, a 27th-order coupler is designed and fabricated, the simulated and measured results have good agreement, showing 20dB of return loss (RL) at all ports, 17dB of coupling, 120 times of frequency ratio and 10-20dB of directivity.
7 December 2021 in IEEE Transactions on Computer-Aided Design of Integrated Circuits and Systems
A parameter extraction method for the LC circuit of a dual-band bandpass filter (DB-BPF) based on the fully connected network is proposed in this article. The network learning process consists of two stages: 1) pretraining and 2) fine-tuning. The network after pretraining has the ability to output the inaccurate values of LC circuit parameters with the desired ${S}$ -parameters (obtained according to the filter design requirements) as input. The precise LC circuit parameters can be obtained from the network during the subsequent fine-tuning process. This parameter extraction method can be applied to LC circuits of various bandpass filters. In addition to the amplitude of S-parameter, the phase of S-parameter is also used as learning data for the pretraining network. Comparative experiments show that the most accurate LC circuit parameters can be predicted using the network trained with phase information compared with the network trained without phase information. Two 7-order narrowband and two 9-order wideband DB-BPFs with four transmission zeros at different center frequencies are designed to demonstrate the validity of the proposed method, and the experimental results show that the proposed method is valid and effective.
4 March 2021 in IEEE Transactions on Circuits and Systems II: Express Briefs
This brief proposes a direct synthesis method for dual-band filters based on frequency transformations. This method can synthesize dual-band bandpass filters (BPFs) with a large range of fractional bandwidth (8.5%-56%) and at the same time, wide center frequency ratio (2-4). A novel circuit conversion scheme is proposed to ease the difficulty of implementing complex circuit and reduce the sensitivity of S parameters to the values of the circuit elements significantly (The influence of 20% fluctuation of inductance on S11 is within 5dB). In order to prove the validity of the proposed method, a 3rd-order narrowband dual-band BPF with center frequencies of 1 GHz and 2 GHz (small frequency ratio) and a 5th-order wideband dual-band BPF with center frequencies of 0.5 GHz and 2 GHz (large frequency ratio) are designed and fabricated, the simulated and measured results have good agreement.
11 November 2022 in International Journal of RF and Microwave Computer-Aided Engineering