1 July 2014 in International Journal of Machine Tools and Manufacture
1 February 2013 in The International Journal of Advanced Manufacturing Technology
27 November 2022 in Journal of Intelligent Manufacturing
11 May 2024 in Measurement
22 June 2017 in Journal of Manufacturing Science and Engineering
When machining narrow grooves, corners, and other complex cavities with trochoidal milling, the irrationally large trochoidal step usually leads to chatter, while the conservative trochoidal step constrains the machining efficiency. In this paper, a stability prediction model of trochoidal milling is established to solve these problems. An approach considering trochoidal steps and spindle speeds is presented to predict stability boundary of trochoidal milling. With considering the varying cutter-workpiece engagements, the stability of trochoidal milling process is predicted by obtaining the stability lobes of different cutter location (CL) points along the trochoidal milling tool paths. Based on the proposed stability model, a trochoidal step optimization strategy is developed to improve the machining efficiency of trochoidal milling under other parameters in a given situation. Cutting experiments are performed on the machining center GMC 1600H/2 to show the effectiveness of the proposed trochoidal milling stability model. Finally, simulations are adopted to illustrate the optimization strategy.
27 October 2015 in Journal of Manufacturing Science and Engineering
In the tool orientation planning for five-axis sculptured surface machining, the geometrical constraints are usually considered. Actually, the effect of nongeometrical constraints on tool orientation planning is also important. This paper studied one nongeometrical constraint which was cutting force induced static deflection under different tool orientations, and proposed a cutter deflection model based on that. In the study of the cutting force, the undeformed chip thickness in filleted end milling was modeled by geometrical analysis and coordinate transformation of points at the cutting edge. In study of static flexibility of multi-axis machine, static flexibility of the entire machining system was taken into consideration. The multi-axis machining system was divided into the transmission axes-handle (AH) end and the cutting tool end. The equivalent shank method was developed to calculate the static flexibility of the AH end. In this method, static flexibility anisotropy of the AH end was considered, and the equivalent lengths of the AH end were obtained from calibration experiments. In cutter deflection modeling, force manipulability ellipsoid (FME) was applied to analyze the static flexibility of the AH end in arbitrary directions. Based on the synthetic static flexibility and average cutting force, cutter deflections were derived and estimated through developing program realization. The predicted results were compared with the experimental data obtained by machining 300 M steel curved surface workpiece, and a good agreement was shown, which indicated the effectiveness of the cutter deflection model. Additional experiments of machining flat workpiece were performed, and the relationship of cutter deflections and tool orientations were revealed directly. This work could be further employed to optimize tool orientations for suppressing the surface errors due to cutter deflections and achieving higher machining accuracy.