1 September 2001 in Nature Biotechnology
15 April 1995 in Journal of Applied Physics
It is well known that bimetallic microcantilevers can exhibit static deflection as a result of thermal effects, including exothermic adsorption of chemicals on their surfaces. It is shown here that the resonance frequency of a cantilever can change due to a combination of mass loading and change of spring constant resulting from adsorption of chemicals on the surface. Cantilevers also undergo static bending that is induced by differential surface stress. The magnitude of these effects depends upon the chemical properties of the surface and upon the amount of material adsorbed. Hence cantilever deflection as well as resonance frequency change can be used as the basis for development of novel chemical sensors.
1 February 2006 in Current Opinion in Chemical Biology
27 March 1995 in Applied Physics Letters
Oscillating silicon nitride microcantilevers coated with a thin gold film have been used to detect mercury vapor in air. Cantilever resonance frequency changes due to surface mass loading as a result of adsorption of mercury vapor. Furthermore, cantilever bending is also altered due to changes in surface stress induced by mercury adsorption on the gold overlayer. Both of these phenomena can be used to quantitatively detect adsorbed vapors with picogram mass resolution.
23 May 1994 in Applied Physics Letters
The deflection of scanning force microscope cantilevers, metal coated on one side, is significantly influenced by both thermal heating and variations in relative humidity. For constant relative humidity, the deflection of the cantilever drifts due to laser heating and eventually reaches a steady-state value. For a thermally stabilized cantilever, the deflection varies linearly with relative humidity. Exposure to other vapors, such as mercury, changes the inherent deflection of the cantilever. Relative amounts of adsorbates on the cantilever can be estimated from shifts in the cantilever resonance frequency with picogram mass resolution. The cantilever deflection as well as changes in resonance frequency due to vapor adsorption can be used as basis for novel chemical sensors.
29 February 2016 in Scientific Reports
A practical method is reported to enhance water permeability of thin film composite (TFC) polyamide (PA) membranes by decreasing the thickness of the selective PA layer. The composite membranes were prepared by interfacial polymerization (IP) reaction between meta-phenylene diamine (MPD)-aqueous and trimesoyl chloride (TMC)-organic solvents at the surface of polyethersulfone (PES) microporous support. Several PA TFC membranes were prepared at different temperatures of the organic solution ranging from −20 °C to 50 °C. The physico-chemical and morphological properties of the synthesized membranes were carefully characterized using serval analytical techniques. The results confirmed that the TFC membranes, synthesized at sub-zero temperatures of organic solution, had thinner and smoother PA layer with a greater degree of cross-linking and wettability compared to the PA films prepared at 50 °C. We demonstrated that reducing the temperature of organic solution effectively decreased the thickness of the PA active layer and thus enhanced water permeation through the membranes. The most water permeable membrane was prepared at −20 °C and exhibited nine times higher water flux compared to the membrane synthesized at room temperature. The method proposed in this report can be effectively applied for energy- and cost-efficient development of high performance nanofiltration and reverse osmosis membranes.