1 September 2021 in Review of Scientific Instruments
Based on the tactile mechanism of human fingertips, a bionic tactile sensor fabricated from polyvinylidene fluoride piezoelectric film is proposed, which can identify the surface softness, viscoelasticity, thermal conductivity, and texture roughness of the object. The tactile sensor is mounted on the fingertip of the bionic manipulator, which obtains the surface features by touching and sliding the object. The time-domain features of the output signal are used for preliminarily discriminating the softness, viscoelasticity, and heat conduction of the object. Finally, based on the Back Propagation and the Particle Swarm Optimization-Back Propagation neural network algorithm, the recognition experiment of texture roughness is carried out using the PSO algorithm to improve the BP neural network so that the optimized BP algorithm has a higher convergence accuracy. The results show that the PSO-BP algorithm achieved the highest accuracy of 98% for identifying samples with different roughnesses and the average recognition achieved an accuracy of 94%. The bionic piezoelectric tactile sensor proposed in this paper has a good application development prospect in recognizing the surface features of objects and intelligent robots.
1 September 2021 in Review of Scientific Instruments
A new type of Ag/AgCl electrode as a marine electric field sensor is prepared using electrospray. The surface of the electrode is porous, and the particle size of AgCl is small and uniform with an average particle size of 1.43 µm, which accelerated the speed of the oxidation–reduction reactions. Therefore, the electrode with large specific surface area has high stability and low noise. The impedance, sensitivity, self-noise, and stability of the electrode are measured to study the electrochemical performance of the electrode. The impedance of the electrode is 7.9 Ω, and the electrode shows resistance characteristics, meaning that the electrode can well receive the weak ocean electric field signals with low signal distortion. The sensitivity experiment result shows that the electrode can well restore the sinusoidal electric field signal of 1 Hz (10 mV). The voltage drift is less than 5 µV/100 h, the self-potential is between −51 and 56 µV, and the self-noise of the electrode is 2.48 nV @ 1 Hz. The AgCl layer on the surface of the electrode is porous and thick, and the particle size of AgCl is small and uniform. This makes the electrode have excellent electrochemical performance. All the experimental results show that the electrode has ultra-low noise and excellent response to low frequency weak electric field signals. The electrode is of great significance to the exploitation of marine resources as the marine electric field sensor.
1 June 2008 in Physica E: Low-dimensional Systems and Nanostructures
1 February 2021 in IOP Conference Series: Earth and Environmental Science
As the important part of historical relics, ancient architectural sites contain an amount of cultural information, which are of great significance for the future development of mankind. But improper prospection methods will lead irreversible damage to the existing architectural sites. Therefore, appropriate detection methods have significant meaning in archeological prospection and cultural relic protection. At present, there are many methods to explore ancient architectural sites, among which three-dimensional electrical resistivity tomography (ERT) methods are gradually popularized, because of its advantages of non-destructive, high efficiency, economic and deep prospection. But there are too many electrode arrays, such as Wenner array, Schlumberger array, dipole-dipole array and pole-pole array. First, this paper briefly introduces the application status of ERT. Then, a simple geoelectric model is constructed, and the inversion results are obtained with different arrays. The comparison of the inversion results for 4 electrode arrays shows that the dipole-dipole array gives the highest resolution. And, a more complex geoelectric model is constructed and compared with the results of the inversion. The results show that conclusions have a good consistency. And, this paper shows that Wenner method and Schlumberger array have high resolution in archeological prospection.