The fabrication of superconducting circuits requires multiple deposition, etching, and cleaning steps, each possibly introducing material property changes and microscopic defects. In this work, we specifically investigate the process of argon milling, a potentially coherence-limiting step, using niobium and aluminum superconducting resonators as a proxy for the surface-limited behavior of qubits. We find that niobium microwave resonators exhibit an order of magnitude decrease in quality factors after surface argon milling, while aluminum resonators are resilient to the same process. Extensive analysis of the niobium surface shows no change in the suboxide composition due to argon milling, while two-tone spectroscopy measurements reveal an increase in two-level system electrical dipole moments, indicating a structurally altered niobium oxide. However, a short dry etch can fully recover the argon-milling-induced losses on niobium, offering a potential route towards state-of-the-art overlap Josephson junction qubits with niobium circuitry.
In this paper, dry etched vertical nanowires (VNWs) are used in transmission line/transfer length analysis to study the contacts of gate-all-around devices for future technology nodes. VNW resistors with Mo and Pd based metal stack contacts to p-InGaAs show Schottky behavior, unlike the planar counterpart. The resistance for Mo contact is higher than Pd, however, Pd was found to form an alloy with InGaAs at temperatures as low as 190 °C, and the length of Pd diffusion into the InGaAs increased at smaller NW dimensions, hindering future scalability. The minimum extracted specific contact resistivity (ρC) values are 1.6 × 10−5 Ω cm2 (Mo) and 4.2 × 10−6 Ω cm2 (Pd) for a doping level of 1 × 1019 cm−3. An apparent dependence of ρC on the NW diameter was also observed. This has been attributed to the surface states under the un-gated region of NW devices and found to dominate at smaller diameters. An analytical model to account for such geometrical effects has also been developed and validated with technology computer-aided design simulations. The analysis presented in this paper effectively captures the 3D aspects of an NW contact at nanoscale dimensions and can be applied irrespective of the semiconductor and contact metal used.
Materials that feature very high permittivity and very low losses at low temperatures offer interesting opportunities for improving the performance of a variety of microwave-optical devices such as phase shifters and quantum transducers. In this Letter, superconducting Al coplanar waveguide resonators between 4 and 6 GHz were used to determine the complex permittivity and loss of thin film SrTiO3 on Si at cryogenic temperatures. We report a permittivity of 1950 ± 140 and a high-power loss tangent (tan δSTO) of 3.4 ± 0.1×10−4 at millikelvin temperatures. To further investigate the potential of SrTiO3 for use in emerging quantum technology applications, the transition of tan δSTO into the single photon regime was analyzed. Our findings reveal a loss scaling that aligns closely with a two-level system loss mechanism. We observe a nearly two orders of magnitude difference in tan δSTO between high and low input power levels, consistent with that two-level system loss picture.