Dragan Trifkovic

Dragan Trifkovic

Auto-generated profile, based on publicly available information

Dragan Trifkovic

University of Defence in Belgrade, Military Academy, Generala Pavla Jurisica Sturma 33, Belgrade, Serbia

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2016
Verified
Book Chapter
Closed access
BKBranimir B. Krstic
Branimir B. Krstic
Bosko RasuoBosko Rasuo
Bosko Rasuo
DTDragan Trifkovic
Dragan Trifkovic
IRIgor Radisavljevic
Igor Radisavljevic
ZRZoran Rajic
Zoran Rajic
MDMirko Dinulovic
Mirko Dinulovic

17 September 2025 in Engineering Failure Analysis
Verified
Journal Article
Closed access
NMNenad Miloradovic
Nenad Miloradovic
KNKatarina Nestorovic
Katarina Nestorovic
DTDragan Trifkovic
Dragan Trifkovic
AAAleksa Anicic
Aleksa Anicic
MPMiloš Pešić Miloš Pešić
Miloš Pešić Miloš Pešić
AKAleksandar Kari
Aleksandar Kari

1 January 2026
Verified
Conference Paper
Closed access
PDF file
EDEnis Dauti
Enis Dauti
DTDragan Trifković
Dragan Trifković
DCDušan Cincar
Dušan Cincar
The subject of this paper is the assessment of the condition of the existing propulsion system of the auxiliary ship PBR-36 "Šabac" from the aspect of the occurrence of increased vibrations on the shaft lines for power transmission to the propeller. The paper presents a detailed and comprehensive approach aimed at detecting the source of increased vibration levels in the propulsion system, which consequently led to the failure of the ship and its decommissioning, which is part of the River Flotilla of the Land Forces. By implementing control vibration measurements, using measuring instruments and diagnostic equipment, the main source of increased vibrations was determined, based on which a recommendation was given for further measures to eliminate malfunctions in the propulsion system. After examining the condition and analyzing the measurement results, the ship PBR-36 "Šabac" was sent to docking, with a focus on repairing the propulsion system. After lifting the ship to the river dock and inspecting it in a disassembled state, the assumptions obtained by the diagnostic equipment were confirmed and the source of increased vibrations in the power transmission system from the engine to the propellers was determined (defective release bearing and misalignment of the propeller shaft). After the work on replacing the defective parts and assemblies of the propulsion system, as well as bringing the eccentricity of the propeller shafts to the permissible deviation limits, the ship was launched into the water, after which control measurements were performed again. A condition assessment was performed and a comparative analysis of the deviations of the measured vibration values after docking was given in relation to the previous report and the reference values defined by the standard. Finally, a conclusion was given with a condition assessment and a proposal for further work.

1 January 2026
Verified
Conference Paper
Closed access
PDF file
VMVuk Milanović
Vuk Milanović
PDPredrag Dobratić
Predrag Dobratić
MSMiloš Sedak
Miloš Sedak
DTDragan Trifković
Dragan Trifković
This paper presents and analyzes the tooth root load-carrying capacity of spur gears under standard single and double mesh conditions. A newly developed analytical model of the relative stress factor is used to approximately determine and compare the tooth root stresses. An Octave program is used to calculate the geometric and kinematic parameters of the pinion and wheel gear. A three-dimensional (3D) model of the pinion and wheel gear is created in CATIA, while two-dimensional (2D) model of their teeth is developed in AutoCAD Mechanical. Bending tests are performed on the gear teeth are performed at characteristic contact points. The tooth root stress values obtained using the finite element method (FEM) are compared with those calculated according to the ISO standard.