Yan Zhu

Yan Zhu

Auto-generated profile, based on publicly available information

Yan Zhu

University of New South Wales

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
27 February 2017 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
CVCarlos Vargas
Carlos Vargas
YZYan Zhu
Yan Zhu
GCGianluca Coletti
Gianluca Coletti
CCCatherine Chan
Catherine Chan
DPDavid Payne
David Payne
ZHZiv Hameiri
Ziv Hameiri
In p-type multicrystalline silicon solar cells, carrier-induced degradation (CID) can cause up to 10% relative reduction in conversion efficiency. Although, a great concern has been drawn on this degradation in the photovoltaic community, the nature of this degradation is still yet unknown. In this contribution, the recombination parameters of the responsible defect causing this degradation are extracted via temperature and injection dependent lifetime spectroscopy. Three wafers from three different ingots were processed into cell precursor and lifetime structures for the study. Similar defect recombination parameters were obtained for all samples. Two candidates for the defect energy level were identified: Et − Ei = −(0.32 ± 0.05) eV or Et − Ei = (0.21 ± 0.05) eV in the lower and upper bandgap halves, respectively. The capture cross section ratios were found to be k = 56 ± 23 or k = 49 ± 21 for the lower and upper bandgap halves, respectively. Contrary to previous studies, these parameters have been extracted for the responsible defect of CID, without making assumptions regarding the defect energy level. The result allows to model and to predict the impact of this defect on the solar cell efficiency.

19 April 2017 in IEEE Journal of Photovoltaics
Verified
Journal Article
Closed access
YZYan Zhu
Yan Zhu
MJMattias Klaus Juhl
Mattias Klaus Juhl
TTThorsten Trupke
Thorsten Trupke
ZHZiv Hameiri
Ziv Hameiri
Photoluminescence imaging is a fast and powerful spatially resolved characterization technique, commonly used for silicon wafers and solar cells. In conventional measurements, homogeneous illumination is used across the sample. In this paper, we present a photoluminescence imaging setup that enables inhomogeneous illumination with arbitrary illumination patterns to determine various parameters of solar cells and solar cell precursors. To demonstrate the strength of the proposed inhomogeneous illumination imaging, a set of proof-of-concept measurements have been conducted; these measurements include contactless series resistance imaging, emitter sheet resistance, and diffusion length measurements. The results indicate that the use of inhomogeneous illumination significantly extends the range of photoluminescence imaging applications for the characterization of silicon wafers and solar cells.

26 March 2019 in IEEE Journal of Photovoltaics
Verified
Journal Article
Closed access
YZYan Zhu
Yan Zhu
MJMattias Klaus Juhl
Mattias Klaus Juhl
GCGianluca Coletti
Gianluca Coletti
ZHZiv Hameiri
Ziv Hameiri
In photoconductance (PC) based carrier lifetime measurement, artificially high values at low-to-medium injection levels are often observed because of the presence of minority carrier traps in the sample. In this paper, we demonstrate that the traps in n-type Czochralski silicon are in a transient regime under the typical quasi-steady-state measurement condition. The trap-associated apparent lifetime in such a transient regime is different from the one in the steady-state condition; thus, traps should be analyzed according to their actual measurement condition. We demonstrate and subsequently propose a method to extract the majority carrier capture the cross section of traps from transient PC decay measurements. Based on different assumptions, the proposed method is complementary to the method proposed by Hornbeck and Haynes. The proposed method is demonstrated with transient PC measurements of a trap in n-type Czochralski silicon wafers.

1 January 2021 in Progress in Energy
Verified
Journal Article
Closed access
PDF file
YZYan Zhu
Yan Zhu
ZHZiv Hameiri
Ziv Hameiri
Characterization and identification of recombination active defects in photovoltaic (PV) materials are essential for improving the performance of solar cells, hence, reducing their levelized cost of electricity. Injection dependent lifetime spectroscopy (IDLS) is a sensitive and widely used technique for investigating defects in silicon. With the development of carrier lifetime measurement techniques and analysis methods, IDLS has gained increasing popularity within the PV research community. In this paper, we review IDLS, from measurement techniques and systems, to existing and emerging defect parameterization methods. We also discuss the limitations and potential pitfalls of lifetime spectroscopy analysis and outline the possible approaches for improvement.

24 April 2017 in IEEE Journal of Photovoltaics
Verified
Journal Article
Open access
YZYan Zhu
Yan Zhu
QGQuoc Thong Le Gia
Quoc Thong Le Gia
MJMattias Klaus Juhl
Mattias Klaus Juhl
GCGianluca Coletti
Gianluca Coletti
ZHZiv Hameiri
Ziv Hameiri
Defect parameter solution surface is a widely accepted method to determine the values of the energy level and the carrier capture cross sections of a defect from injection-dependent lifetime measurements. Results of the defect parameter solution surface come from the recognition of intersection points, which can be difficult when the doping or the temperature range of the measurement is narrow. In this paper, we introduce a new method to extract the defect parameters from lifetime spectroscopy data. After linearization of the Shockley-Read-Hall (SRH) lifetime equation, the problem is transformed into a mathematical form, which can be solved by the Newton-Raphson method. This method requires a much shorter computing time and directly provides the possible values of the defect parameters without user interaction, even for measurements with narrow doping and temperature ranges.

27 August 2019 in AIP Conference Proceedings
Verified
Conference Paper
Open access
PDF file
YZYan Zhu
Yan Zhu
FRFiacre Rougieux
Fiacre Rougieux
NGNicholas Grant
Nicholas Grant
JMJack Mullins
Jack Mullins
JGJoyce Ann De Guzman
Joyce Ann De Guzman
ZHZiv Hameiri
Ziv Hameiri
Float-zone silicon has been long assumed to be bulk defect free and stable. Nevertheless, recently it was found that upon annealing between 450 °C to 700 °C detrimental defects can be activated in this material. Previous studies via deep level transient spectroscopy have identified several defect levels. However, it is still not clear which of these levels have a substantial impact on the minority carrier lifetime. In this study, we determine the recombination parameters of the dominant defect level using a combination of deep level transient spectroscopy and temperature and injection dependent lifetime spectroscopy. Additionally, we investigated the effect of hydrogenation on the thermally activated defects in n- type float-zone silicon.