1 There is research interest currently in the development of new treatment technologies for melts made from low-grade batch. Such technologies must be resource-saving and must guarantee the required alloy properties in castings. According, we need to develop a technology for the production of cast aluminum alloys and the corresponding castings, including several classical methods of melt treatment, in the optimal combination. In the present work, we outline a resource-saving technology for the production of cast aluminum alloys on the basis of low-grade batch. This technology corresponds to optimal timed heat treatment of the melt.
The results of study on aluminum alloys of grade AK9M2 AK12M2 are provided. Alloy crystallization time for alloys AK9M2 AK12M2 decreases, the intensity of reduction depends on the vibration amplitude. For alloys AK9M2 and AK12M2 the optimal amplitude is 2^2.2 mm, allowing a dense cast alloy with a fine grain structure to be obtained. Density of samples from AK12M2, cut from the bottom part, is slightly increases with the rise of the vibration amplitude.
26 September 2016 in IOP Conference Series: Materials Science and Engineering
The article provides analysis of results of gray iron experimental melts in induction furnace and the following melt modification with barium-strontium carbonate (BSC-2). It is shown that modification positively affects mechanical and casting properties and as-cast iron structure. It was established that BSC-2 granulated immediately prior to use has greater impact on melt than BSC-2 of the same faction, supplied by the manufacturer.
The correlation between the thermodynamic properties (activity) of liquid solutions and the physical properties (thermoemf) of Fe-X-C solid solutions is considered.
30 March 2026 in Bulletin of the Siberian State Industrial University
OPTIMIZATION OF TECHNOLOGICAL PARAMETERS OF CASTING USING PHYSICO-INFORMED GENERATIVE MODELS TO MINIMIZE DEFECTS IN STEEL CASTINGS | Kutsenko | Bulletin of the Siberian State Industrial University ОПТИМИЗАЦИЯ ТЕХНОЛОГИЧЕСКИХ ПАРАМЕТРОВ ЛИТЬЯ С ИСПОЛЬЗОВАНИЕМ ФИЗИКО-ИНФОРМИРОВАННЫХ ГЕНЕРАТИВНЫХ МОДЕЛЕЙ ДЛЯ МИНИМИЗАЦИИ ДЕФЕКТНОСТИ СТАЛЬНЫХ ОТЛИВОК | Куценко | Вестник Сибирского государственного индустриального университета