Hunan Province Key Laboratory for Ultra-Fast Micro/Nano Technology and Advanced Laser Manufacture, School of Electrical Engineering, University of South China, Hengyang 421001, P. R. China
Auto-generated profile, based on publicly available information
Hengjun Chen
Hunan Province Key Laboratory for Ultra-Fast Micro/Nano Technology and Advanced Laser Manufacture, School of Electrical Engineering, University of South China, Hengyang 421001, P. R. China
We report on the efficient high-power operation of a laser-diode-pumped Er3+-doped yttrium aluminum perovskite (Er:YAP) laser in the 3 m spectral region at room temperature. 6.9 W of continuous-wave (CW) output power was obtained at 2920 nm. The slope efficiency was as high as 30.6% with respect to the absorbed pump power, which is close to the quantum defect limit (33.4%). To the best of our knowledge, this is the highest CW output power generated from 3 m Er3+-doped solid state lasers at room temperature. Furthermore, our analysis has shown that more than 10 W of output power based on Er:YAP is possible by further mitigating the thermal lens effect.
We report laser operation of two Tb3+-activated gain media, Tb:LiYF4 and LiTbF4, in yellow or/and green spectral region. A record-high slope efficiency of 63% among Tb3+-lasers and maximum output power of 1.17 W (incident power of 2.79 W) at around 544 nm were obtained with a c-cut 15%Tb:LiYF4 crystal. The yellow laser characteristics in σ-polarization were studied. A slope efficiency of 21% at 582 nm was achieved. More importantly, we succeeded in laser operation of LiTbF4 for the first time to the best of our knowledge. Laser oscillation at around 544 nm yielded a maximum slope efficiency of 45%. This points toward the possibility of producing high-energy pulsed lasers using LiTbF4, which features a high active-ion concentration as well as relatively long lifetime.
Potassium terbium fluoride (KTF) crystal is a promising magneto-active material for creating multi-kilowatt average-power Faraday isolators operating at the visible and near-infrared wavelengths. Nevertheless, the key material’s parameter needed for the design of any Faraday isolator—the Verdet constant, has not been comprehensively investigated yet. In this Letter, we report on measurement of the Verdet constant of the KTF crystal for wavelengths between 600 and 1500 nm and for temperatures ranging from 15 to 295 K. A suitable model for the Verdet constant as a function of wavelength and temperature has been developed and may be conveniently used for optimal design of KTF-based high-average-power Faraday isolators.
We report the -switched operation of a -laser for the first time, to the best of our knowledge. The passive -switching was realized by a 15% gain medium and a single-layer graphene saturable absorber. An average output power of 744 mW at 544 nm was achieved with slope efficiency of 41%, pulse width of 2.9 µs, and repetition rate of 38.7 kHz. The corresponding pulse energy and peak power were calculated to be 19.2 µJ and 6.6 W, respectively.
Deep-ultraviolet (DUV) light sources are critical owing to their high photon energies and small diffraction limits, and synthetic quartz glass (SQ) is suitable for the Faraday rotators of DUV light. The Verdet constant in SQ was evaluated within the wavelength range of 190–300 nm. In addition to a high Verdet constant over the DUV region, this material exhibits a high transmittance without transitional absorption bands. The Verdet constants were found to be 70.1 rad/(T·m) at 193 nm, which is the shortest observed wavelength for silica glass. SQ glass has excellent structural properties; thus, it is suitable as a DUV Faraday rotator for high-average-power optical isolators.
We report laser operation of Pr:YAlO3 pumped by a frequency-doubled optically pumped semiconductor laser. Continuous-wave laser oscillations at around 622 nm, 662 nm, and 747 nm were demonstrated in plano-concave or/and plano-plano cavities. The maximum slope efficiencies were found to be 37%, 35%, and 59%, respectively, which are record-high values for Pr:YAlO3 lasers. Furthermore, lasing at 622 nm was demonstrated at room temperature for the first time to the best of our knowledge.