This paper presents an experimental system dedicated for the detection and tracking of small aerial targets such as Unmanned Aerial Vehicles (UAVs) in particular small drones (multirotors). The system was proposed in response to increasing drone popularity and the related threats. The hardware and software parts of the system are covered, including the analogue front-end, FPGA based pre-processing and PC based processing, detection and tracking. Real life trials are described with promising results provided. Further research on the subject is proposed.
2 February 2017 in Journal of Marine Engineering & Technology
Catastrophic Flight Data Recorders (FDRs), the so-called black boxes, belong to the on-board equipment, the task of which is not only to operate properly while recording selected parameters under all flight conditions but also to protect the recorded data against the loss in the aircraft crash conditions. The requirements related to catastrophic resistance of FDRs are defined in the European standard EuroCAE ED-112 and the Polish standard NO-16-A200:2015. One of the requirements includes the catastrophic recorder’s resistance to the acceleration overload of 3400 g. The compliance with the standard is checked during crash tests. In this paper, a procedure of planning and carrying out the mentioned tests for S2-3a-K protected unit of S2-3a catastrophic FDR manufactured by the Air Force Institute of Technology was described. It is an iterative procedure involving consecutive experimental tests and both analytical and numerical calculations. The experimental tests were performed using a DPZ-250 pneumatic gun. The testing probe was shot at the target of sand deposits of modified geometry and mass characteristics. Effectiveness of the developed procedure was shown by comparing the experimental results, namely recordings of the probe deceleration captured with a fast camera, with results of numerical simulation of the probe terminal ballistic.
1 January 2014 in Journal of KONES. Powertrain and Transport
Flight data recorder is a device that records various flight parameters and is able to survive the crash for increasing aviation safety. Aircrafts which can have an impact on the safety of flights in the airspace are becoming smaller and more accessible. Good examples are unmanned aerial vehicles or ultralight aircrafts. It would be appropriate to equip these objects with flight data recorders in order to ensure that every crash will be accompanied to improvement of the aviation safety. While the legitimacy of FDR (flight data recorder) installation into manned objects is pretty obvious, for a UAV (unmanned aerial vehicle) it is not so clear. There are some cases that the UAV has dropped and damaged some facilities or even dropped on human, additionally loss of often very expensive object should occur as rarely as possible. In both cases, the lifting capacity is very limited so there is requirement to significantly reduce the weight of the recording device. Minimum dimensions and weight are strongly dependent on the assumed conditions of the accident and on the size of the aircraft. The paper describes design of the electronics module, partial concepts of the whole flight data recorder and the first crash survival tests.
Instytut Techniczny Wojsk Lotniczych has for years been engaged in research and development (R&D) aimed at the determination of wear-and-tear level that particular aircraft suffer from. The paper has been intended to present an innovative measuring-and-recording system to collect information on service loads that arise in structural components of the Su-22UM3K aircraft. Research work into loads in some selected structural components of the Su-22UM3K has been carried out with the KAM-500 measuring system applied. Modular design has been used to develop the system. This, in turn, allows of changes in the system’s configuration, according to what a measuring task requires. The flight testing of loads has covered items of tasks included in the flying training program for the Su- 22UM3K to collect/deliver data on an actual service profile and to determine representative strain-gauge measuring channels to be utilized in further aircraft’s service.
The subject of the research was a catastrophic recorder of the S2-3a system for recording flight parameters, developed at the Air Force Institute of Technology. The article discusses tests of catastrophic recorders’ resilience to factors present at aircraft accidents. The document specifying the requirements for catastrophic recorders of flight parameters includes the defence standard: NO-16-A200, and the European standard: EuroCAE ED-112. According to NO-16-A200 and ED-112 standards, the protective unit should be resistant to: g-forces existing during crash, puncture, compression, fire, underwater pressure and aggressive liquids.