Tin oxide (SnO2) semiconductor is recognized as a highly promising material for the electron transport layer (ETL) in perovskite solar cells (PSC) due to their wide band gap energy and high electron mobility. This material has been considered as the potential alternative material for substituting the conventional titanium dioxide (TiO2). In the form of nanostructure material, it is expected that SnO2 as the ETL in PSC device can be significantly improved owing to its high surface area leading to more intensive photon absorption. In this present study, SnO2 nanoparticles were synthesized via the hydrothermal method with temperature variations ranging from 120 °C to 160 °C for 16 hours. The as-synthesized samples were characterized using X-ray diffraction (XRD), scanning electron microscope (SEM), and an ultraviolet–visible (UV-Vis) spectrophotometer. The SnO2 nanoparticles were then integrated into the PSC device as the ETL, and the performance testing was conducted using a semiconductor parameter analyzer to obtain the I-V curve. On the basis of investigation results, it has been found that the temperature used during the hydrothermal process plays a crucial role in determining the crystallinity, morphology, and band gap energy of the SnO2 nanoparticles. The results of the PSC performance test indicate that SnO2 nanoparticles synthesized at a hydrothermal temperature of 150 °C demonstrated the highest power conversion efficiency (PCE) of 3.89 %. This outcome confirms the viability of SnO2 nanoparticles produced through the hydrothermal method
The extraction of ilmenite minerals using the sulfate route is one of the commercial methods for producing titanium dioxide (TiO2) materials. The sulfate process requires a high concentration of sulfuric acid to achieve high extraction yield of titanium. However, this process also results in the generation of high amounts of sulfuric acid waste. Modifying ilmenite minerals is thought to be one of approaches in reducing the consumption of highly concentrated sulfuric acid. In the current study, we investigated the effect of the ilmenite-to-water mass ratio (ITWR) on the wet-ball milling process to enhance the dissolution of titanium from the ilmenite mineral. The results revealed that increasing the water amount from 10 to 70% wt has decreased the particle size from 167.60 to 0.55 μm and increased the titanium yield from 479.36 to 1228.89 ppm. On the basis of investigation, it was shown there is a significant relationship between the ilmenite-to-water mass ratio and titanium dissolution, highlighting the importance of an optimal ratio for achieving maximum dissolving yield. The obtained TiO2 nanoparticles provide the average crystallite size of 4.16 nm, with rutile and anatase phase, and spherical morphology.