Kesen Ding

Kesen Ding

Auto-generated profile, based on publicly available information

Kesen Ding

School of Electronic Science and Engineering, University of Electronic Science and Technology of China, Chengdu, China

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
3 January 2020 in IEEE Electron Device Letters
Verified
Journal Article
Closed access
Zhigang LuZhigang Lu
Zhigang Lu
KDKesen Ding
Kesen Ding
RWRuidong Wen
Ruidong Wen
WGWeihua Ge
Weihua Ge
MZMeiling Zhu
Meiling Zhu
YGYubin Gong
Yubin Gong

9 April 2020 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
Zhigang LuZhigang Lu
Zhigang Lu
MZMeiling Zhu
Meiling Zhu
KDKesen Ding
Kesen Ding
RWRuidong Wen
Ruidong Wen
WGWeihua Ge
Weihua Ge
YGYubin Gong
Yubin Gong
Traveling wave tube (TWT) is an attractive solution for wideband and high-power sources or amplifiers in the terahertz (THz) band. In this article, a novel slow-wave structure (SWS) for TWT, named double tunnel sine waveguide (DTSW), which is based on sine waveguide (SW), is proposed. The following key technologies are adopted: 1) the rectangular holes, at which the operating mode is cutoff, are alternately opened on the sine-shaped ridges to form two electron beam tunnels and 2) the lower surface of rectangular holes is flush with the top of sine-shaped ridges. Compared with the SW-SWS, DTSW-SWS has the wider operating band and higher interaction impedance under the condition that the phase velocity of the two SWSs is at the same level. In addition, DTSW-SWS is simple in structure and easy to fabricate. The particle-in-cell simulation results reveal that DTSW-TWT has an output power of more than 202 W in the frequency range of 202-255 GHz with the maximum power of ~405 W and electron efficiency of ~9.8% at 215 GHz, under the operating voltage of 23 kV and beam current of 180 mA. Therefore, the DTSW should be considered as a promising SWS for the high-power and wideband THz traveling wave amplifier.

5 December 2022 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
SGSen Gong
Sen Gong
DPDianyuan Ping
Dianyuan Ping
CBChunyang Bi
Chunyang Bi
ZZZhenpeng Zhang
Zhenpeng Zhang
SLShixiong Liang
Shixiong Liang
YZYaxin Zhang
Yaxin Zhang
The developing terahertz wireless communication demands higher performance modulators. In this Letter, a mechanism of resonance mode transformation for a high-speed terahertz direct amplitude modulator with rather low insertion loss and high modulation depth is presented. By embedding an H-shaped resonance structure, which consists of a fin-line and two flip-flopped GaAs Schottky diodes, into the E-wall of a waveguide, the fed terahertz waves are modulated by the inductive-capacitive (LC) resonance transformation of the structure. Based on this mechanism, a modulator working in the frequency band around 140 GHz is fabricated and packaged. Thanks to the LC resonance transformation, the presented modulator exhibits a low insertion loss of 1.8 dB at 138 GHz, a large modulation depth higher than 99% at 148 GHz, and high modulation speeds up to 30 Gbps at 146 GHz. Accordingly, the presented mechanism paves a promising route to develop high performance terahertz direct modulators, which is of great significance for terahertz high-speed wireless communication.

29 March 2023 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
TZTianchi Zhou
Tianchi Zhou
YDYazhou Dong
Yazhou Dong
SGSen Gong
Sen Gong
SLShixiong Liang
Shixiong Liang
KDKesen Ding
Kesen Ding
YZYaxin Zhang
Yaxin Zhang
High-speed direct modulation devices are of great significance for the development of high-speed communication systems with large bandwidth, miniaturization, and low complexity. However, an increase in the carrier frequency in the sub-terahertz band and above will negatively impact high-performance direct modulation devices due to the large insertion loss and low on–off ratio. Based on the traveling-wave modulation mechanism, this article adopts the zero-phase-difference amplitude modulator design method. More specifically, a 1- $\mu$ m small anode Schottky diode is combined with a Z-type matching structure to form a dual-resonant coupling dynamic tunable unit. Interunit coupling is found to further improve the on–off ratio. In this way, high-speed dynamic modulation is performed for the transmission traveling-wave amplitude with low insertion loss and a high on–off ratio. On this basis, a 0.14-THz on–off keying (OOK) high-speed traveling-wave modulator is proposed, and our results showed that a on–off ratio of 25.4 dB could be achieved at the zero-phase-difference point by only using two dynamic structural units. Meanwhile, the control voltage could be adjusted to achieve high-speed modulation with a phase difference of only 3.66 $^\circ$ during the entire control voltage transition, a data rate of 24 Gb/s, and 33.99% sidebands occupation.

10 January 2024 in IEEE Electron Device Letters
Verified
Journal Article
Closed access
KDKesen Ding
Kesen Ding
YAYu Ao
Yu Ao
HFHailong Fang
Hailong Fang
CBChunyang Bi
Chunyang Bi
LCLiyu Cheng
Liyu Cheng
YZYaxin Zhang
Yaxin Zhang
In this letter, a terahertz ultra wideband high-speed on-chip modulator based on coupling resonance was proposed. By nesting multiple diodes in the coplanar waveguide to form multiple composite modulation units, the equivalent physical state of meta-units is controlled by external voltage signal, and then control the electromagnetic resonance characteristics of the modulation units to achieve high-speed broadband modulation of terahertz waves. This modulation mechanism simplifies the resonant structure, suppresses the parasitic parameters and improves the modulation rate of the existing terahertz external modulator. The bandwidth is expanded through cascade coupling resonance, thus realizing ultra-wideband amplitude modulation of terahertz waves transmitted in coplanar waveguides. The experimental results show that the high-speed ultra-broadband modulation of terahertz waves is achieved at 110 GHz-160 GHz with a maximum modulation depth of 15dB (97%) and a maximum modulation rate of 30 Gbps, providing a promising prospect for the development and application of the integrated terahertz direct modulation technology.

20 January 2025 in Applied Physics Letters
Verified
Journal Article
Closed access
KDKesen Ding
Kesen Ding
CBChunyang Bi
Chunyang Bi
YAYu Ao
Yu Ao
LCLiyu Cheng
Liyu Cheng
HFHailong Fang
Hailong Fang
YZYaxin Zhang
Yaxin Zhang
In this paper, we propose a sub-terahertz PAM4 modulator based on transmission characteristic reconstruction by combining meta-unit, GaAs Schottky diode, and fan branch lines. This method combined the significant electromagnetic resonant characteristics of meta-unit, the high-speed controllability of GaAs Schottky diode, and the high integration of on-chip transmission line together to realize high-speed modulation. Then, we achieve transmission characteristic reconstruction by adjusting the resonance strength under different applied voltages through fan branch lines, enabling high-order amplitude modulation of sub-terahertz waves. The experimental results show that the PAM4 modulation of sub-terahertz waves is achieved with a nearly linear variation of the transmission coefficient in the whole voltage range and a maximum modulation rate of 21 Gbps, providing a promising prospect for the development and application of integrated sub-terahertz direct high-order modulation technology.