13 April 2020 in Applied Physics Letters
Scandium nitride (ScN) is an emerging rock salt III-nitride semiconductor and has attracted significant interest in recent years for its potential thermoelectric applications as a substrate for high-quality epitaxial GaN growth and as a semiconducting component for epitaxial single-crystalline metal/semiconductor superlattices for thermionic energy conversion. Solid-solution alloys of ScN with traditional III-nitrides such as AlxSc1−xN have demonstrated piezoelectric and ferroelectric properties and are actively researched for device applications. While most of these exciting developments in ScN research have employed films deposited using low-vacuum methods such as magnetron sputtering and physical and chemical vapor depositions for thermoelectric applications and Schottky barrier-based thermionic energy conversion, it is necessary and important to avoid impurities, tune the carrier concentrations, and achieve high-mobility in epitaxial films. Here, we report the high-mobility and high-thermoelectric power factor in epitaxial ScN thin films deposited on MgO substrates by plasma-assisted molecular beam epitaxy. Microstructural characterization shows epitaxial 002 oriented ScN film growth on MgO (001) substrates. Electrical measurements demonstrated a high room-temperature mobility of 127 cm2/V s and temperature-dependent mobility in the temperature range of 50–400 K that is dominated by dislocation and grain boundary scattering. High mobility in ScN films leads to large Seebeck coefficients (−175 μV/K at 950 K) and, along with a moderately high electrical conductivity, a large thermoelectric power factor (2.3 × 10−3 W/m-K2 at 500 K) was achieved, which makes ScN a promising candidate for thermoelectric applications. The thermal conductivity of the films, however, was found to be a bit large, which resulted in a maximum figure-of-merit of 0.17 at 500 K.
23 December 2022 in Advanced Electronic Materials
Traditional computation based on von Neumann architecture is limited by time and energy consumption due to data transfer between the storage and the processing units. The von Neumann architecture is also inefficient in solving unstructured, probabilistic, and real‐time problems. To address these challenges, a new brain‐inspired neuromorphic computational architecture is required. Due to the absence of resistance–capacitance delay, high bandwidth, and low power consumption, optoelectronic artificial synaptic devices are highly attractive. Yet, stable, scalable, and complementary metal–oxide–semiconductor (CMOS)‐compatible materials exhibiting both inhibitory and excitatory optoelectronic synaptic functionalities have not been demonstrated. Here, epitaxial CMOS‐compatible scandium nitride (ScN) optoelectronic artificial synaptic devices that emulate both inhibitory and excitatory biological synaptic activities are presented. The negative and positive persistent photoconductivity of undoped and magnesium‐doped ScN is equated to the inhibitory and excitatory synaptic plasticity, respectively, which leads to functionalities like learning–forgetting, frequency‐selective optical filtering, frequency‐dependent potentiation and depression, Hebbian learning, and logic‐gate operations. Temperature‐dependent photoresponse and photo‐Hall measurements reveal that scattering of photogenerated carriers from charged defect centers results in negative photoconductivity in undoped degenerate ScN. This work opens up the possibility of utilizing a group‐III epitaxial semiconducting nitride material with inhibitory and excitatory optoelectronic synaptic functionalities for practical neuromorphic applications.
20 May 2022 in ACS Applied Energy Materials
15 February 2023 in Nanoscale Horizons
Sharma et al. show an all-optical artificial synapse using a reversible, photochromic organic compound, spiropyran, stimulated by optical pulses. This work shows that spiropyran can be an excellent host for artificial photonic synapses.
23 November 2020 in Applied Physics Letters
Scandium nitride (ScN) is an emerging rock salt indirect bandgap semiconductor and has attracted significant interest in recent years for thermoelectric energy conversion, as a substrate for defect-free GaN growth, as a semiconducting component in single-crystalline metal/semiconductor superlattices for thermionic energy conversion, as well as for Al1−xScxN-based bulk and surface acoustic devices for 5G technologies. Most ScN film growth traditionally utilizes physical vapor deposition techniques such as magnetron sputtering and molecular beam epitaxy, which results in stoichiometric films but with varying crystal quality, orientations, microstructures, and physical properties. As epitaxial single-crystalline ScN films with smooth surfaces are essential for device applications, it is important to understand the ScN growth modes and parameters that impact and control their microstructure. In this Letter, we demonstrate that large adatom mobility is essential to overcome the Ehrlich–Schwoebel (E–S) and grain boundary migration barriers and achieve defect (voids, dislocations, stacking faults, etc.)-free single-crystalline ScN films. Using the substrate temperature to tune adatom mobility, we show that nominally single-crystalline ScN films are achieved when the homologous temperature is higher than ∼0.3. For homologous temperatures ranging from 0.23 to 0.30, ScN films are found to exhibit significant structural voids in between pyramidal growth regions with multiple in-plane orientations resulting from additional lateral growth off the facets of the pyramids and broken epitaxy after ∼80 nm of growth. The in-depth discussion of the growth modes of ScN presented here explains its varying electrical and optical properties and will help achieve high-quality ScN for device applications.
22 November 2024 in Science Advances
Plasmon resonance represents the collective oscillation of free electron gas density and enables enhanced light-matter interactions in nanoscale dimensions. Traditionally, the classical Drude model describes plasmonic excitation, wherein plasma frequency exhibits no spatial dispersion. Here, we show conclusive experimental evidence of the breakdown of plasmon resonance and a consequent metal-insulator transition in an ultrathin refractory plasmonic material, hafnium nitride (HfN). Epitaxial HfN thick films exhibit a low-loss and high-quality Drude-like plasmon resonance in the visible spectral range. However, as the film thickness is reduced to nanoscale dimensions, Coulomb interaction among electrons increases because of electron confinement, leading to the spatial dispersion of plasma frequency. With a further decrease in thickness, electrons lose their ability to shield the incident electric field, turning the medium into a dielectric. The observed metal-insulator transition might carry some signatures of Wigner crystallization and indicates that such transdimensional, between 2D and 3D, films can serve as a promising playground to study strongly correlated electron systems.