In laser‐based direct energy deposition (DED‐LB) additive manufacturing (AM), wire or powder materials are melted by a high‐power laser beam. Process‐specific characteristics enable robust in situ fabrication of compositionally graded materials, e.g., through an adaption of powder mass flow from independent hoppers. Based on the high flexibility of this approach, pathways toward multimaterial AM have been unlocked. Obviously, such characteristics enable high‐throughput alloy development. However, rapid alloy development demands substantial characterization efforts to assess phase and microstructural evolution. So far, property analysis is considered as the limiting factor for these high‐throughput approaches. Herein, the use of high‐brilliance X‐Ray analysis and subsequent micropillar compression testing are introduced to tackle these challenges. As a proof of concept, their application to a compositionally graded material made from AISI 316L stainless steel and a CoCrMo alloy is presented. The results obtained reveal that X‐Ray analysis can be exploited to evaluate process robustness, chemical characteristics, and phase composition within the gradient regions. Moreover, the use of micropillar compression testing provides spatially resolved insights into the mechanical properties of the gradient regions. The combination of both characterization techniques eventually opens pathways toward a robust and time‐efficient alloy development using powder‐fed DED‐LB (DED‐LB/P).
Prestressing of concrete is a commonly used technique in civil engineering to achieve long spans, reduced structural thicknesses, and resource savings. However, in terms of application, complex tensioning devices are necessary, and prestress losses due to shrinkage and creep of the concrete are unfavourable in terms of sustainability. In this work, a prestressing method using novel Fe-Mn-Al-Ni shape memory alloy rebars as a tensioning system in UHPC is investigated. A generated stress of about 130 MPa was measured for the shape memory alloy rebars. For the application in UHPC, the rebars are prestrained prior to the manufacturing process of the concrete samples. After sufficient hardening of the concrete, the specimens are heated inside an oven to activate the shape memory effect and, thus, to introduce the prestress into the surrounding UHPC. It is clearly shown that an improvement in maximum flexural strength and rigidity is achieved due to the thermal activation of the shape memory alloy rebars compared to non-activated rebars. Future research will have to focus on the design of the shape memory alloy rebars in relation to construction applications and the investigation of the long-term performance of the prestressing system.
A microstructural informed thermodynamic model is utilized to tailor the pseudoelastic performance of a series of Fe–Mn–Al–Ni shape‐memory alloys. Following this approach, the influence of the stability and the amount of the B2‐ordered precipitates on the stability of the austenitic state and the pseudoelastic response is revealed. This is assessed by a combination of complementary nanoindentation measurements and incremental‐strain tests under compressive loading. Based on these investigations, the applicability of the proposed models for the prediction of shape‐memory capabilities of Fe–Mn–Al–Ni alloys is confirmed. Eventually, these thermodynamic considerations enable the guided enhancement of functional properties in this alloy system through the direct design of alloy compositions. The procedure proposed renders a significant advancement in the field of shape‐memory alloys.