30 September 2024 in Nature Electronics
12 December 2022 in Nature Electronics
17 October 2019 in Journal of Physics D: Applied Physics
Separation of the anomalous Nernst and spin Seebeck voltages in bilayer devices is often problematic when both layers are metallic, and the anomalous Nernst effect (ANE) becomes non-negligible. Co2MnSi, a strong candidate for the spin generator in spin Seebeck devices, is a predicted half-metal with 100% spin polarisation at the Fermi energy, however, typically B2 or L21 order is needed to achieve this. We demonstrate the optimisation of thin film growth of Co2MnSi on glass, where choice of deposition and annealing temperature can promote various ordered states. The contribution from the ANE is then investigated to inform future measurements of the spin Seebeck. A maximum ANE coefficient of 0.662 µV K−1 is found for an A2 disordered polycrystalline Co2MnSi film. This value is comparable to ordered Heusler thin films deposited onto single crystal substrates but obtained at a far lower fabrication temperature and material cost.
6 October 2021 in Macromolecules
The elastic modulus and hydrophilicity of cross-linked poly(dimethylsiloxane) (PDMS) are tunable via cross-linker concentration and the addition of a simple surfactant, C12E4, before curing. However, the surfactant concentration, [C12E4], reduces the elastic modulus (73% lower for 6.3% w/w) because it reduces the extent of curing. This is likely because the hygroscopic surfactant results in water poisoning of the catalyst. Three distinct time-dependent hydrophilicity profiles were identified using water contact angle analysis with [C12E4] determining which profile was observed. This indicates the concentration-dependent phase behavior of C12E4 within PDMS films. Changes in phase behavior were identified using small-angle neutron scattering (SANS) and a compatibility study. No surface excess or surface segregation of surfactant was observed at the PDMS–air interface. However, a surface excess revealed by neutron reflectivity against a D2O interface indicates that the increase in hydrophilicity results from the migration of C12E4 to the film interface when exposed to water.
1 December 2020 in APL Materials
We demonstrate the manipulation of magnetic phases in FeRh thin films through atomic displacements and the distribution of structural defects. Atomic scale disorder can be controlled via irradiation with light noble gas ions, producing depth-varying nanoscale phase configurations of distinct antiferromagnetic, ferromagnetic, and paramagnetic regions. Here, we perform a spatial characterization of the magnetic phases and the local magnetic environment around the Fe atoms, as well as the variation of the open-volumes around atomic sites. Thus, a direct correspondence between the existence of the three magnetic phases and lattice defects is revealed. By careful selection of the irradiating fluence, we show that it is possible to produce simple and thermally stable magnetic configurations, such as uniform magnetization or a bilayer phase structure. Furthermore, the thin film surface and interfaces are observed as the nucleation sites for the transitions between the phases. These results demonstrate a sensitive nanoscale manipulation of magnetic properties, shedding light on magnetic ordering in alloy lattices and broadening the scope for applications.
9 October 2012 in Journal of Physics D: Applied Physics
Bismuth thin films of thickness in the region of 500 nm have been prepared by planar magnetron sputtering onto glass, silicon and GaAs substrates. Electron microscopy of these films reveals that bismuth whiskers grow spontaneously when the substrate is heated to temperatures between 110 and 140 °C during deposition and the optimum temperature for such growth is largely independent of substrate. Depositing films under similar conditions using thermal evaporation does not, however, produce the whisker growth. X-ray diffraction has been employed to investigate film texture with temperature and it has been shown that the film crystallites are predominantly [1 1 0] and [1 1 1] oriented. The [1 1 0] orientation of the crystallites dominates at deposition temperatures above 110 °C for sputter deposition and the [1 1 1] at lower temperatures. The optimum temperature for whisker growth coincides with the temperature for the change between predominant orientations. While sputter deposition appears to favour films with crystallite orientation of [1 1 0], thermal evaporation favours [1 1 1] and has a higher change-over temperature. The whiskers that grow from the film emerge at off-normal angles between 43.3° and 69.2° with a mean of 54 ± 3°. The projected length of whiskers on a 500 nm film on a GaAs substrate shows a wide distribution to a maximum of more than 100 µm. The mean projected length for this sample was 16 ± 1 µm and the diameter is around 0.5 µm. Measurements of the electrical properties of the whiskers at room temperature reveals ohmic behaviour with an estimated resistivity of 2.2 ± 0.2 µΩ m. Detailed examination of scanning electron micrographs, eliminates all growth mechanisms except tip growth by a non-catalysed vapour–solid/vapour–liquid–solid method. By depositing thinner films it is shown that this spontaneous growth of whiskers offers a route to fabricate high quality bismuth nanowires of lengths exceeding 10 µm.