23 September 2019 in IEEE Journal of Solid-State Circuits
This article proposes a general-purpose hybrid in-/near-memory compute SRAM (CRAM) that combines an 8T transposable bit cell with vector-based, bit-serial in-memory arithmetic to accommodate a wide range of bit-widths, from single to 32 or 64 bits, as well as a complete set of operation types, including integer and floating-point addition, multiplication, and division. This approach provides the flexibility and programmability necessary for evolving software algorithms ranging from neural networks to graph and signal processing. The proposed design was implemented in a small Internet of Things (IoT) processor in the 28-nm CMOS consisting of a Cortex-M0 CPU and 8 CRAM banks of 16 kB each (128 kB total). The system achieves 475-MHz operation at 1.1 V and, with all CRAMs active, produces 30 GOPS or 1.4 GFLOPS on 32-bit operands. It achieves an energy efficiency of 0.56 TOPS/W for 8-bit multiplication and 5.27 TOPS/W for 8-bit addition at 0.6 V and 114 MHz.
19 February 2004 in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
In this paper we address the growing issue of gate oxide leakage current (I/sub gate/) at the circuit level. Specifically, we develop a fast approach to analyze the total leakage power of a large circuit block, considering both I/sub gate/ and subthreshold leakage (I/sub sub/). The interaction between I/sub sub/ and I/sub gate/ complicates analysis in arbitrary CMOS topologies and we propose simple and accurate heuristics based on lookup tables to quickly estimate the state-dependent total leakage current for arbitrary circuit topologies. We apply this method to a number of benchmark circuits using a projected 100-nm technology and demonstrate accuracy within 0.09% of SPICE on average with a four order of magnitude speedup. We then make several observations on the impact of I/sub gate/ in designs that are standby power limited, including the role of device ordering within a stack and the differing state dependencies for NOR versus NAND topologies. Based on these observations, we propose the use of pin reordering as a means to reduce I/sub gate/. We find that for technologies with appreciable I/sub gate/, this technique is more effective at reducing total leakage current in standby mode than state assignment, which is often used for I/sub sub/ reduction.
27 March 2017 in IEEE Transactions on Electron Devices
Wireless biomedical implantable devices on the millimeter-scale enable a wide range of applications for human health, safety, and identification, though energy harvesting and power generation are still looming challenges that impede their widespread application. Energy scavenging approaches to power biomedical implants have included thermal, kinetic, radio frequency, and radiative sources. However, the achievement of efficient energy scavenging for biomedical implants at the millimeter-scale has been elusive. Here, we show that photovoltaic cells at the millimeter-scale can achieve a power conversion efficiency of more than 17% for silicon and 31% for GaAs under 1.06 μW/mm 2 infrared irradiation at 850 nm. Finally, these photovoltaic cells demonstrate highly efficient energy harvesting through biological tissue from ambient sunlight, or irradiation from infrared sources such as used in present-day surveillance systems, by utilizing the near infrared transparency window between the 650-and 950-nm wavelength range.
26 May 2016 in IEEE Transactions on Electron Devices
GaAs photovoltaics are promising candidates for indoor energy harvesting to power small-scale ( $\approx 1$ mm 2 ) electronics. This application has stringent requirements on dark current, recombination, and shunt leakage paths due to low-light conditions and small device dimensions. The power conversion efficiency and the limiting mechanisms in GaAs photovoltaic cells under indoor lighting conditions are studied experimentally. Voltage is limited by generation–recombination dark current attributed to perimeter sidewall surface recombination based on the measurements of variable cell area. Bulk and perimeter recombination coefficients of 1.464 pA/mm 2 and 0.2816 pA/mm, respectively, were extracted from dark current measurements. Resulting power conversion efficiency is strongly dependent on cell area, where current GaAs of 1-mm 2 indoor photovoltaic cells demonstrates power conversion efficiency of approximately 19% at 580 lx of white LED illumination. Reductions in both bulk and perimeter sidewall recombination are required to increase maximum efficiency (while maintaining small cell area near 1 mm 2 ) to approach the theoretical power conversion efficiency of 40% for GaAs cells under typical indoor lighting conditions.
12 September 2019 in IEEE Journal of Solid-State Circuits
This article presents a voice and acoustic activity detector that uses a mixer-based architecture and ultra-low-power neural network (NN)-based classifier. By sequentially scanning 4 kHz of frequency bands and down-converting to below 500 Hz, feature extraction power consumption is reduced by 4x. The NN processor employs computational sprinting, enabling 12x power reduction. The system also features inaudible acoustic signature detection for intentional remote silent wakeup of the system while re-using a subset of the same system components. The measurement results achieve 91.5%/90% speech/non-speech hit rates at 10-dB SNR with babble noise and 142-nW power consumption. Acoustic signature detection consumes 66 nW, successfully detecting a signature 10 dB below the noise level.
15 October 2019 in IEEE Journal of Solid-State Circuits