1 September 2024 in AIP Advances
Relativistic backward wave oscillators (RBWOs) have the characteristics of high power and high repetition rate. Reducing the magnetic field strength and the weight of the external permanent magnet (PM) is a significant development direction of RBWOs. In previous research, an X-band RBWO enclosed with a PM has achieved a power efficiency of 50%. However, the PM used in these papers requires a magnetic field magnitude of over 0.68 T, which leads to a weight exceeding 400 kg. The RBWO designed in this paper operates in coaxial TM01 mode, and the radial distance between its cathode and the surface of the slow wave structures reaches 7 mm. Under the condition of a low magnetic field, this design can provide a wide electron beam channel to avoid the rubbing of the electron beam envelope on the inner and outer conductors. Particle-in-cell simulation results have demonstrated that this RBWO achieves an output microwave power of 3 GW with a power efficiency of 50% enclosed in a PM with a magnetic field strength of 0.43 T and a weight of 74 kg.
1 December 2023 in Review of Scientific Instruments
The electromagnetic characteristics of the input cavity with electron beams loaded are measured successfully in an X-band triaxial relativistic klystron amplifier (TKA) with a high frequency electrical probe. To solve the frequency response issue in the X band, a coaxial electrical probe is optimized and inserted obliquely into the input cavity at the designed angle so that the microwaves in the cavity can be sampled and extracted with the required coupling coefficient while the probe does not interfere with the solenoid coil, which is tightly integrated outside the TKA. Besides, the TKA is redesigned as a structure integrally sealed by the solenoid coil, and the secondary sealing induced by probe insertion is implemented on the flange of the solenoid coils rather than on the wall of the TKA, which is conducive to simplifying the coupling structure while maintaining the high vacuum level. The design is examined in a GW level TKA experiment, indicating that microwaves with a power of about 670 MW are generated in the input cavity at a frequency of 8.40 GHz, which is completely consistent with the injected and output microwave frequencies.
1 October 2024 in Physics of Plasmas
This paper introduces a high-power broadband X-band klystron amplifier that achieves an output power of 157 MW and a 3 dB operating bandwidth of 6.7%. The amplifier employs an explosive emission diode with high impedance, which balances the requirements of high power and broadband. The multi-gap input and output cavities are designed to operate at two different longitudinal modes within the operating frequency band, resulting in a flat absorption rate and output efficiency. Moreover, an eight-stage stagger-tuned bunching section is implemented to achieve a uniform fundamental harmonic current modulation depth across the frequency band. Simulation results indicate that when the diode voltage is 550 kV and the beam current is 550 A, the amplifier can achieve a maximum power of 157 MW with an efficiency of 51.9% at the central frequency of 9.8 GHz. Furthermore, within the 3 dB operating bandwidth of 6.7% (670 MHz), the power output remains higher than 80 MW. This novel klystron amplifier structure exhibits exceptional performance in terms of bandwidth, power, and efficiency, thus validating the effectiveness of the design in enhancing bandwidth and providing a solid foundation for the broadband design of high-power microwave sources.
1 September 2025 in AIP Advances
In order to overcome the bottleneck of improving the bunching depth of intense-current electron beams in klystron, this study proposes a design scheme of high bunching depth based on the staggered distribution of resonant cavity frequencies. By optimizing the high-frequency parameters and spatial configuration of the resonant cavities, the defects of limited modulation depth (typical value less than 120%) and long drift section in the traditional relativistic klystron bunching structure are solved. Under the condition of electron beam voltage of 420 kV, beam current of 8.5 kA, guiding magnetic field of 0.4 T, and 1.5% pre-modulation ratio, the scheme achieves 164.2% electron beams modulation depth over only three wavelength drift distances, which successfully verifies the feasibility of compact beam dynamics design. The compact bunching structure of the innovative frequency combination not only provides an effective way to break through the size limitation of the X-band GW-level high power devices but also has important technical support significance for the modular integrated development of the spatial power coherent combining system.
1 January 2025 in AIP Advances
To achieve coherent power combination of Ka-band high-power microwave (HPM), a phase-locked klystron-type coaxial relativistic Cherenkov generator (PKC-RCG), which combines the advantageous characteristics of weak dimensional sensitivity of RCG and low input power ratio of relativistic triaxial klystron amplifier (TKA), is proposed and investigated in this paper. The PKC-RCG is composed of two parts: a pre-modulation region adapted from TKA and an energy exchange region adapted from RCG. The pre-modulation region is used for initial speed modulation of intense relativistic electron beams (IREB), ensuring that the output frequency is consistent with the input frequency. The energy exchange region is used for deep clustering of the IREB and achieving efficient beam–wave energy conversion. Phase locking of the output HPM is accomplished through phase delivery of the modulated IREB. Specially designed reflectors and cascaded single-gap bunching cavities with active suppression of asymmetric TM mode are employed in the pre-modulation region to suppress energy coupling and achieve a lower input power ratio. Disk-loaded slow-wave structure with smooth inner conductor is employed in the energy exchange region to further decrease the dimensional sensitivity of RCG. By the proposed Ka-band PKC-RCG, an HPM with a power of 550 MW and a frequency of 29.0 GHz is obtained with ohmic loss being taken into account. Moreover, the input power ratio and phase-locking bandwidth of the proposed Ka-band PKC-RCG are −51.4 dB and 30 MHz, respectively.
1 February 2025 in AIP Advances
A Ku-band phase-locked coaxial relativistic Cherenkov generator with a low guiding magnetic field is presented. Owing to the use of the combined periodic double-corrugation slow-wave structure, the quasi-TEM mode exhibits a strong axial electric field at the center of the beam tunnel. As a result, the electron beam can achieve effective beam–wave interaction without proximity to the SWS surfaces, allowing the electron beam with a larger envelope and, therefore, reducing the demand for strong guiding magnetic fields. Two single-gap cascaded pre-modulation cavities are used to reduce the demand for the injected signal and to improve the power ratio of the output microwave to the input signal. Particle-in-cell simulation results show that, under a guiding magnetic field of 0.65 T, an injected signal with a power of 5 kW can lock the frequency and phase of a 966 MW output microwave, where the bandwidth is about 60 MHz and the phase instability is within ±2°. In addition, the efficiency is about 40%, and the power ratio of the output microwave to the input signal is ∼53 dB.