1 April 2022 in IEEE Transactions on Magnetics
A review of advanced Fe-based amorphous and nanocrystalline soft magnetic alloys that are currently being used in the market and their primary industrial applications is discussed as well as emerging trends. The high-efficiency distribution transformer market continues to be the largest segment by volume for Fe-based amorphous foil. The industry has been shifting toward higher induction levels (1.63 T) with increased stacking factor (>90%) to minimize the transformer size and reduce costs. New magnetic domain refined grades of amorphous foil are now commercially available which show a reduction of ~25% in core losses compared to the standard amorphous material. Nanocrystalline soft magnetic alloys have become the standard material for many applications including low-loss electrical components, magnetic shielding, electronic filtering, medium frequency transformer cores, and a variety of others. The nanocrystalline alloys are commonly cast fully amorphous and devitrified through controlled heat treatments. New nanocrystalline alloy compositions and processing methods have enhanced both the mechanical and magnetic performance of the final properties. Amorphous and nanocrystalline alloys show promise for use in electric motors but fabrication challenges for limited their commercial adoption.
12 July 2021 in Journal of Coatings Technology and Research
9 June 2023 in IEEE Transactions on Magnetics
Recently developed FeNi-based metal amorphous nanocomposites (MANCs) used in high-speed motors (HSMs) exhibit reduced eddy current losses while maintaining good mechanical properties and glass-forming abilities. Magnetic anisotropy in (Fe 70 Ni 30 ) 80 Nb 4 B 14 Si 2 amorphous magnetic ribbon (AMR) in the as-cast state and upon conventional (T CA ) and strain (T SA ) annealing heat treatment is investigated. From ribbon samples in as-cast condition, quenched in stress from planar flow casting (PFC) induced as-cast curvature derived uniaxial magnetic anisotropy. Stress relief by conventional furnace annealing at T CA > 350 °C achieved isotropic properties in the bulk. Annealing about the primary crystallization temperature, T CA ~ 450 °C, resulted in the formation of both FCC and BCC nanocrystallites and evolution to isotropic bulk magnetic properties confirming the random anisotropy model. In samples strain annealed at T SA = 440 °C at various tensions, relatively large controlled induced uniaxial anisotropy is achieved. The largest magnetic anisotropy occurs in annealing under the stress of 250 MPa yielding an anisotropy field of 7.1 x 10 4 A/m. Surface anisotropy observed by MOKE differs from bulk anisotropy due to image contrast from closure domains. Epoxy coatings are important for improved bonding, mechanical properties, and resistivity in tape-wound MANC cores for HSMs. Using a sessile droplet method, the equilibrium contact angle of an epoxy droplet on a tensile stress annealed MANC exhibits stress dependent surface energies. Anisotropic wetting in FeNi-based MANC heat treated at T CA = 440 °C mimics surface magnetic anisotropy observed by MOKE.