27 April 2021 in IEEE Access
This paper presents performance improvement of dual stator axial-flux spoke type permanent magnet vernier machine (DSAFST-PMVM), which has the capability to generate high torque at a lower speed due to magnetic gearing effect. Flux focusing effect is created by means of dual stator single rotor topology with spoke type permanent magnets. It is best suitable for high-performance industrial applications such as servo motors, robot arms, wind power, electric vehicles, and elevator applications. A PM shape is proposed in this paper which has notches in such a way that it produces discrete skew effect which reduces the cogging torque and torque ripples. Optimization of magnet shape is done to make the optimized model more competitive than the proposed and basic models. Main parameters such as back emf, cogging torque, torque ripples, electromagnetic torque, VTHD, airgap flux densities, flux density distribution, power factor, and power of the machine are compared among the basic model, proposed model, and optimized models. The comparative analysis is done by using the time stepped 3D finite element method.
22 November 2019 in IEEE Access
This paper reports on a novel technique of switching radiation characteristics electronically between E-and H-planes of planar Substrate Integrated Waveguide Leaky Wave Antennas (SIW-LWAs). The leaky wave mode is achieved through increasing the pitch of bounding metallic via posts on one side of SIW transmission section. The radiation switching is achieved by extending the top and bottom metallic planes to a distance of 1 mm along the leakage side. The extended section acts as a parallel plate section which is conveniently connected or disconnected from the leaking side of SIW through PIN diodes. The ‘ON’ state of PIN diodes extends the metal guides and results in the H-plane leakage whereas ‘OFF’ state of PIN diodes truncates the extended metal earlier and alter the leakage line boundary condition towards E-plane. The whole concept is validated by series of simulations followed by the realization and testing of the SIW-LWA. The measured radiation pattern scans about 54° in the E-plane between 10.0 GHz to 11.7 GHz, and 58° in the H-plane from 9 GHz to 10.6 GHz. The proposed topology is a suitable candidate for remote sensing and airborne applications.
24 April 2020 in IEEE Access
As the usage of wireless technology grows, there are evermore demands on the antennas that support these platforms. This need has led to the design of unique antennas with improved bandwidth, agile frequency capabilities, compact size and greater efficiencies. In part though, the trade-off for such capabilities is antenna complexity. This paper presents a new technique for simplifying the method of changing the operation of a printed antenna using micron-sized silver coated particles that respond to magneto-static fields. More specifically, a structure consisting of a low-loss dielectric material with a cylindrical cavity containing micro-sized particles is developed. The overall size of the dielectric material is 1.5 mm×1.5 mm×0.5 mm and the cavity has a diameter of 0.9 mm. Furthermore, the top and bottom of the cavity with the micron-sized particles is capped with copper foil. Then, to manipulate the enclosed particles, a static magnet is placed near the structure. The enclosed particles columnize and orientate in the direction of the field-lines, connecting the top and bottom copper foil plates. To disconnect the plates then, the field is simply removed and the columns collapse. Macroscopically, the structure has the behavior of a switch. The structures presented in this work are denoted as Magneto-static Field Responsive Structures (MRSs). The MRSs have an additional benefit of not requiring a direct connection to a biasing circuit. This is very useful because there are many antenna designs that make it difficult to embed biasing circuitry to reconfigure printed antennas using MEMS and PIN diodes, for example. Finally, a new frequency reconfigurable Electromagnetic Band Gap (EBG) antenna is presented. This design is unique because the complex layout does not allow for traditional biasing circuitry and the operation is changed using the new MRSs presented in this paper.