Yudong Wang

Yudong Wang

Auto-generated profile, based on publicly available information

Yudong Wang

College of Biological and Chemical Engineering, Guangxi University of Science and Technology, Liuzhou 545006, P. R. China

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
5 January 2022 in Industrial & Engineering Chemistry Research
Verified
Journal Article
Closed access
GSGuangwu Sun
Guangwu Sun
WHWanli HAN
Wanli HAN
YWYudong Wang
Yudong Wang
SXSanfa Xin
Sanfa Xin
JYJingru Yang
Jingru Yang
CXChangfa Xiao
Changfa Xiao

1 July 2019 in Applied Surface Science
Verified
Journal Article
Closed access
CJChangchun Ji
Changchun Ji
YWYudong Wang
Yudong Wang
NZNing Zhao
Ning Zhao

28 May 2020 in ACS Omega
Verified
Journal Article
Closed access
YWYudong Wang
Yudong Wang
JZJianping Zhou
Jianping Zhou
XGXiaoping Gao
Xiaoping Gao

1 November 2017 in Materials Letters
Verified
Journal Article
Closed access
YWYudong Wang
Yudong Wang
TLTianshun Liao
Tianshun Liao
MSMiao Shi
Miao Shi
CLCong Liu
Cong Liu
XCXiaofeng Chen
Xiaofeng Chen

8 June 2022 in ACS Omega
Verified
Journal Article
Open access
GSGuangwu Sun
Guangwu Sun
YWYudong Wang
Yudong Wang
YZYinjiang Zhang
Yinjiang Zhang
WHWanli HAN
Wanli HAN
SSShanshan Shang
Shanshan Shang
Solution blowing (SB) is a widely reported technology that can be used to fabricate fibers at the micro- and nanoscale. To reveal the fibrous web formation mechanism in SB, we improved our previous melt blowing (MB) model to predict fibrous web structures. Then, we fabricated two samples and simulated the same number of virtual samples in the computer to verify the model. Thereafter, we measured the structural parameters including the fiber diameter, fiber orientation, basis weight, and pore size. Our model provides a good prediction of the fiber orientation and basis weight. However, the predicted fiber diameter was slightly smaller than the measured diameter. The experimental pore size distribution was also different from that in the simulated results. The model provides a virtual fabrication process to reveal a fibrous web formation mechanism and finds a similar distribution of these structural parameters between SB and MB.

25 July 2020 in Journal of Polymer Engineering
Verified
Journal Article
Closed access
YWYudong Wang
Yudong Wang
JZJianping ZHOU
Jianping ZHOU
In order to investigate the effect of the slot ends of the melt-blowing die on the three-dimensional airflow field distribution and the fiber draft, the numerical calculation was carried out. The computational domain of the slot die was established with Gambit, and the flow field was calculated using FLUENT. Compared with the experimental data collected by a hot-wire anemometer, the numerical calculation results are credible. The results show that the slot end face has a certain influence on the three-dimensional flow field distribution under the melt-blowing die. The air velocity and temperature in the center region are quite different from those near the slot-end face. As the distance from the center of the flow field increases, the velocity and temperature on the spinning line begin to decrease. The velocity and temperature distributions of the spinning lines in the central area and nearby areas are almost the same; the temperature and velocity values on the spinning lines near the slot end are the lowest. The distribution characteristics of the three-dimensional airflow field could affect the uniformity of the fiber diameter and the meltblowing products.