5 June 2009 in IEEE Transactions on Applied Superconductivity
Many full size conductors for the ITER TF coils have been tested at the SULTAN test facility in Switzerland for conductor qualification. JAEA tested two samples and two kinds of Nb3Sn strands were evaluated through the tests. Now another sample named JATF3 has been tested, which uses two other kinds of Nb3Sn strands. The strands satisfy the critical current density Jc requirement, but results of the conductor test were lower than our expectation. After the test, JAEA has been investigating the reason by X-ray CT scan and destructive inspection, and has found a possible reason.
1 January 2024 in IEEE Transactions on Industry Applications
This paper presents a Universal Smart Power Module (USPM) which responds instantaneously to fluctuating power sources such as solar and wind power and fully addresses the rapidly expanding renewable energy market by combining universality and smartness. USPM consists of a main circuit as an H-bridge converter, high-speed controller, gate driver, and EMI filter into one module. Conventional power electronics design requires complicated know-how and specialized skills such as circuit design, digital control, thermal design, and EMI. The USPM concept simplifies the power electronics design because this system realizes every power converter by a combination of several USPMs. The USPM system consists of the master controller and several USPMs. The master controller gives voltage and current commands to USPMs by wireless communication to regulate the operation of USPMs. USPM realizes excellent feedback control by the high-speed controller in order to follow the command from the master controller rapidly. The core power module using the wide-bandgap device in USPM is also developed to improve the switching characteristics and the power density of USPM. As the technology for ultra-miniaturization, ADB (Atomic Diffusion Bonding) is developed and applied to the drain side of the SiC-MOSFET to achieve low thermal resistance, and bumping technology to the source side of it to achieve low inductance. This paper introduces the detail of the concept of the USPM systems and the core power module. Finally, the example of the USPM system for the PV power conditioner is demonstrated by the experiment.
29 September 2014 in IEEE Transactions on Applied Superconductivity
We describe herein the characteristics of a Nb 3 Sn cable inserted into a conduit (cable-in-conduit conductor) for the International Thermonuclear Experimental Reactor toroidal field (TF) coil and central solenoid (CS). During insertion, the pulling force almost linearly increases as a function of the length Ii of cable is inserted. The slope of these curves for the CS cables are approximately 74% that for the TF cable, although the mass per unit length of the CS cable is approximately 63% that of the TF cable. Thus, friction between the CS cable and the conduit is slightly greater than that between the TF cable and the conduit. The number Np of rotations at the cable point for the TF cable increases to 50 almost linearly versus Ii. For I i <; 150 m, Np for the CS cables also increases almost linearly with a slightly greater slope than for the TF cable. However, the slope decreases, and Np becomes constant at 30 for Ii ) 600 m. During compaction, the number Nt of rotations at the tail of the TF cable, the 613-m-long CS cable, and the 918-m-long CS cable increases almost linearly versus compacted cable length to 23, 36, and 69, respectively. The X-ray transmission imaging of the CS conductor clarifies the distributions of the fifth-stage twist pitch of the cable (Ip) over the entire length of the conductor. These results are consistent with a geometric analysis based on Np and Nt. The results for Ip peak at the cable point; thus, a sample of the conductor should be taken from the point to investigate how Ip elongation affects conductor performance.
1 January 2016 in Teion Kogaku (Journal of Cryogenics and Superconductivity Society of Japan)