The purpose of the work was to test the welded joints of aluminum alloys EN AW-7075 and EN AW-6082, which are used to join individual structural elements of car bodies, e.g., B-pillar with the body. The joints were made using the low-energy cold metal transfer (CMT) arc welding method. The results of the structure investigations of lap and butt joints, as well as tests of mechanical properties are presented. The influence of linear energy and the way of arranging materials in lap joints on the possibility of hot cracks occurrence has been demonstrated. The shear strength of lap joints was equal to 150 MPa, while the tensile strength of butt joints was equal to 375 MPa. The highest hardness reduction was observed in the heat affected zone (HAZ) from the EN AW-7075 alloy side in the range of 98 to 138 HV 0.05. In addition, a significant reduction of the corrosion resistance in the transition zone between HAZ and the base material (EN AW-7075 alloy) in the medium salinity environment, corresponding to the sea conditions according to ASTM G85 was indicated.
The paper presents the influence of the brazing gap width on the structure of bonded joints during the production of aluminum heat exchangers, using brazing technology, in tunnel furnaces with controlled atmosphere. Based on the wedge test, an analysis and qualitative assessment of brazed joints was made for the changing width of the brazing gap and the filler metal used. For the received brazed joints, metallographic tests were carried out using light and electron microscopy (SEM) and microhardness measurements in the characteristic areas of brazed joints. Based on the results obtained, the recommended width of the brazing gap was determined.
28 December 2021 in Archives of Metallurgy and Materials
On the basis of research, the mechanisms of dissolution and erosion during brazing of aluminium alloys and the influence of these phenomena on brazed joints of heat exchangers are presented. A number of factors have been identified that affect the formation of these phenomena during brazing aluminium alloys, these include : the maximum temperature and holding time at brazing temperature, and the type and amount of filler metal. The research was supported by examples of dissolution and erosion phenomena during series production of aluminium heat exchangers using three brazing profiles (normal, hot and very hot). It has been found that the dissolution of the engine radiator components during brazing, is from 18 to 68%, depending on the brazing profile used. For a very hot profile, erosion in part of the brazed exchanger, even destroys (removes) thin elements of the cooling fins.