Wan-Rone Liou

Wan-Rone Liou

Auto-generated profile, based on publicly available information

Wan-Rone Liou

Department of Electrical Engineering, National Taipei University, Taiwan

Research Focus & Metrics

Academic Career Length

20Years (2007-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
21 December 2012 in IEEE Transactions on Industrial Informatics
Verified
Journal Article
Closed access
WLWan-Rone Liou
Wan-Rone Liou
WLWalton B. Lacorte
Walton B. Lacorte
ACAileen B. Caberos
Aileen B. Caberos
MYMei-Ling Yeh
Mei-Ling Yeh
JLJia-Chuan Lin
Jia-Chuan Lin
CSChih-Shiang Sun
Chih-Shiang Sun
This paper presents the design of a low-cost programmable controller integrated circuit (IC) for general power electronics applications. The architecture of the programmable controller IC consists of 10-bit ADC and DAC, programmable counter array (PCA), which is configured to function as PWM, and a control unit (processor) for regulation. The processor unit is configured as digital compensator, through fewer program steps to perform accurate compensation on the voltage control loop of the converter system. Limit-cycle oscillation is minimized through inclusion of a sufficiently low integral gain term in the control law. A hybrid control method is first used to control the input voltage and current waveforms to achieve a unity power factor correction. It is observed that the programmable converter achieves the high efficiency power conversion. The conversion efficiency of the digital controlled boost converter is 91% with a 0.8% ripple voltage performance. While in power factor correction (PFC) circuit application, the power factor and output ripple voltage of converter are 0.995 and 0.93%, respectively. The chip is implemented with TSMC 0.25 um CMOS process.

22 May 2007 in International Journal of Electronics
Verified
Journal Article
Closed access
WLW.-R. Liou
W.-R. Liou
TCT.-H. Chen
T.-H. Chen
MYM.-L. Yeh
M.-L. Yeh
JHJ.-J. Ho
J.-J. Ho
GJG. E. Jan
G. E. Jan
A fully integrated dual-band LC voltage control oscillator, designed in a 0.18-µm CMOS technology for 5.8-GHz/2.0-GHz wireless communication applications, is described. The frequency band switching is accomplished with switched-inductor technique. The dual-band oscillator can be operated in 5.38–6.23 GHz and 1.78–2.07 GHz with 15% frequency tuning range. Two different inductors are used for the frequency band switching. Frequency tuning is implemented by varying the capacitance of a MOS varactor. The measured phase noise is −109 dBc/Hz @ 1 MHz and −112 dBc/Hz @ 1 MHz for frequency at 5.8 GHz and 2 GHz, respectively. This oscillator is fabricated in UMC's 0.18-µm one-poly-six-metal 1.8 V process. The power dissipation of this dual-band VCO is 11.7 and 9.3 mW for oscillation frequency of 2 GHz and 5.8 GHz, respectively.

1 July 2007
Verified
Conference Paper
Closed access
WLWan-Rone Liou
Wan-Rone Liou
TCTsung-Hsing Chen
Tsung-Hsing Chen
YKYueh-Lung Kuo
Yueh-Lung Kuo
THTang-Yu Huang
Tang-Yu Huang
MYMei-Ling Yeh
Mei-Ling Yeh
This paper presents the design of a novel wide output current range dual-mode DC to DC step-down (buck) switching regulator/converter. The converter can adaptively switch between pulse-width modulation (PWM) and pulse-frequency modulation (PFM) both with very high conversion efficiency. Soft start operation is designed to eliminate the excess large current at the start up of the regulator. The chip has been fabricated with a TSMC 2P4M 0.35 mu m polycide CMOS process. The range of the operation voltage is from 2.7 V to 5 V, which is suitable for single-cell lithium-ion battery supply applications. The maximum conversion efficiency is 95% at 50 mA load current. Above 85 % conversion efficiency can be reached for load current from 3 to 460 mA.

1 July 2007
Verified
Conference Paper
Closed access
YLYao-Chian Lin
Yao-Chian Lin
MYMei-Ling Yeh
Mei-Ling Yeh
WLWan-Rone Liou
Wan-Rone Liou
CCC.C Chang
C.C Chang
A low-noise amplifier (LNA) with tunable output matching network is designed for a frequency band 3.9~7.1 GHz. The LNA gain can be tuned by varying the control voltage of varactor. The gain tuning range are 3 and 5.5 dB at 3.9 and 7.1 GHz, respectively. A maximum gain of 13.68 dB is obtained. The LNA consumes 22.8 mW with a supply of 1.5 V. The resistive shunt-feedback technique is used to design this broadband LNA. The LNA is fabricating in 0.1 mum standard CMOS process.

22 September 2010 in Microwave and Optical Technology Letters
Verified
Journal Article
Closed access
MYMei-Ling Yeh
Mei-Ling Yeh
YLYao-Chian Lin
Yao-Chian Lin
WLWan-Rone Liou
Wan-Rone Liou
SKSheng-Hing Kuo
Sheng-Hing Kuo
PRPatrick Roblin
Patrick Roblin
CCC.C Chang
C.C Chang