16 July 2025 in IEEE Transactions on Antennas and Propagation
This paper explores and validates the effectiveness of the multimodal transfer-matrix method (MMTMM) for accurate Bloch analysis of generic one-dimensional (1D) periodic leaky-wave structures. The method offers a systematic methodology for computing the complex wavenumbers of both proper and improper leaky modes by using the multimodal transfer matrix of a single unit cell, which can be obtained with commercial software. The versatility and accuracy of the MMTMM are first validated for rectangular waveguides loaded with periodic slots, where the leaky mode arises as a perturbation of the fundamental waveguide mode. Its applicability is further demonstrated for more complex surface-wave-supporting periodic structures commonly used in leaky-wave antennas, including corrugated surfaces and grounded-dielectric strip gratings. The results are verified against ad hoc solutions using the method of moments. The reliability of the method is demonstrated by the convergence of the solutions from multiple simulations. The MMTMM proves to be an efficient, accurate, and reliable means of obtaining the leakage constant and phase shift of general 1D-periodic open structures.
15 May 2025 in IEEE Transactions on Microwave Theory and Techniques
This article presents the design and experimental validation of a W-band waveguide cavity filter operating around 91 GHz, using a periodic electromagnetic bandgap (EBG) structure with glide symmetry to implement the filter in a stack of multiple thin metallic sheets without electric contact between them. The filter is based on vertically stacked cavities that use the TE103 mode, which offers increased robustness to manufacturing and assembly errors due to the large dimensions of the cavity. The glide-symmetric circular hole EBG structure is analyzed and integrated to suppress unwanted field leakage between the metallic layers with a broad stopband. The proposed filter maintains effective operation in the 88–94-GHz frequency range, even with gap variations between layers of up to $20~\mu $ m. The filter is fabricated using laser cutting, achieving a low surface roughness and high dimensional accuracy. Experimental measurements show excellent agreement with the simulations, with a return loss greater than 20 dB and an insertion loss below 0.5 dB. These results demonstrate the possibility to achieve high performance filters at millimeter-wave frequencies while maintaining low fabrication complexity and cost using the multilayer waveguide technology.