Research Center in Engineering and Applied Sciences, Autonomous University of the State of Morelos, Av. Universidad 1001, Cuernavaca 62209, Morelos, Mexico
Auto-generated profile, based on publicly available information
Nestor Belisario Gomez-Guzman
Research Center in Engineering and Applied Sciences, Autonomous University of the State of Morelos, Av. Universidad 1001, Cuernavaca 62209, Morelos, Mexico
This study reports the behavior of the Ni20Cr alloy in molten nitrate salts. Its behavior was evaluated in the eutectic mixture called Solar Salt (binary salt) and in a ternary mixture (90% Solar Salt and 10% lanthanum nitrate). The addition of lanthanum nitrate was performed to determine if the presence of the La3+ cation could act as a corrosion inhibitor. Through mass loss and potentiodynamic polarization studies, the effects of both electrolytes on the corrosion resistance of the alloy at 300, 400, and 500 °C and at exposure times of 250, 500, 750, and 1000 h were determined. The results showed an increase in the corrosivity of the ternary salt, due to a decrease in its melting point and an increase in the concentration of nitrate ions. However, it was observed that the La3+ cations formed a protective layer (La2O3) on the alloy surface. In both corrosive media, the Ni20Cr alloy showed excellent corrosion resistance, due to its ability to form protective layers of Cr2O3, NiO, and NiCr2O4, in addition to the presence of a layer of La2O3 in the case of the ternary salt.
This work reports the performance of a green corrosion inhibitor with double hydrocarbon chain. The evaluated inhibitor was a dialkyl-diamide from coffee bagasse oil and its electrochemical behavior was evaluated on an API-X52 steel in CO2-saturated brine at 60 °C. The electrochemical behavior was determined by measurements of open circuit potential, polarization resistance, and electrochemical impedance spectroscopy. In addition, the thermodynamic parameters of the corrosion process were obtained in the temperature range from 40 °C to 80 °C. Electrochemical studies showed that the inhibitor is capable of suppressing metal dissolution by up to 99% at 25 ppm. On the other hand, the thermodynamic parameters indicate that when adding the inhibitor, there is a strong increase in both Ea and ΔH° values, and that as time increases, they decrease until reaching similar values to those observed in the absence of the inhibitor. Furthermore, ΔS° values tend to become more negative with immersion time because of the formation of a stable film on the metal surface.
The interest in studying the synthesis of an Al–Cr alloy system by non-equilibria processes is due to the formation of metastable or quasicrystalline phases when rapid solidification has been utilized. Similarly, the formation of quasicrystals has been reported to a much lesser extent when the mechanical alloying technique was applied. In the present research, a mixture of powders of Cr and Al (both elements with a purity of 99.99%) with compositions of Al-5 and 7.5 at. % Cr was subjected to a ball milling process. Afterwards, the powder mixture was subjected to a consolidation process, conducted by pressing and sintering processes. The X-ray diffraction analyses revealed that during 20 h of milling there was no formation of metastable or quasicrystalline second phases detected. In addition, the X-ray diffraction peaks revealed that as milling time increased, the nanometric grain size decreased, and once the sintering treatment was applied, the crystallite size decreased following the same tendency. The dislocation density was estimated using the size of nanometric grains; this computation revealed that the dislocation density grew throughout the ball milling process; even after sintering, the multiplication of dislocations prevailed following the same tendency.