5 April 2022 in IEEE Access
Microgrids gain popularity due to their economical and environmental benefits along with less power losses and smaller infrastructure. But it has a number of fundamental governance and operational challenges such as power quality, power system instability, reliability, and protection issues. Microgrid protection strategy is a prime issue for reliable operation of microgrid in the real world. The strategy must meet the essential conditions in AC and DC microgrid protections both in grid-connected and islanded operational modes. Different protection schemes have been developed as published in several different research articles but they are not suitable or efficient for both modes of operation due to operational challenges in microgrid protection. This paper presents a comprehensive review and comparative analysis of protection schemes and their implementation challenges for different microgrid architectures with various operational requirements. The challenges associated with the implementation of microgrid protection schemes are identified and discussed in detail. Further, various simulation studies have been conducted to demonstrate the microgrid protection challenges associated with different operational strategies. This paper presents key information to researchers and protection engineers to identify microgrid protection challenges and their solutions.
25 January 2022 in IEEE Transactions on Industry Applications
This paper presents an adaptive rate of change of frequency (ROCOF) based passive Islanding detection technique (IDT) to overcome the non-detection zone (NDZ) issue and limitation of existing islanding detection techniques. The proposed ROCOF based passive IDT relies on the settings of the phase locked loop (PLL) closed loop control system for frequency, ROCOF and threshold ROCOF value for the PCC relay setting calculations. So, the PLL results in alternate frequency and ROCOF output value with respect to the PLL settings modification. The PLL settings can be different in different types of microgrid systems. Therefore, the proposed adaptive ROCOF based IDT provides a generic solution for islanding detection applications for the safe and reliable operation of different types of microgrid systems. The adaptive ROCOF based IDT is developed and implemented on two different types of the microgrid systems such as (I) generator based microgrid (ii) generator, PV and storage based hybrid microgrid in Matlab/Simpower System. Results showed that the proposed IDT successfully detected the islanding condition even with zero power mismatch and it is fully capable to distinguish between islanding (loss of mains and external fault) and non-islanding (internal fault, load switching, motor starting etc.) conditions with a diverse range of operating conditions.
29 February 2024 in IEEE Transactions on Industry Applications
This paper designs three coordinated control schemes for a grid-connected wind energy conversion system based on a permanent magnet synchronous generator. The system includes a static synchronous compensator (STATCOM) and a supercapacitor energy storage (SCES) to maintain stable operation during different operating conditions. Coordinated control scheme-I (CCS-I) integrates the SCES into the DC-link via a bidirectional DC/DC converter to stabilize the voltage under varying wind speeds and grid disturbances. Coordinated control scheme-II (CCS-II) uses a STATCOM at the point of common coupling (PCC) to enhance the grid voltage stability during voltage sag or swell, where the SCES balances active power, and the grid side converter (GSC) provides reactive power support. The STATCOM is only activated when the PCC's reactive power requirement exceeds the GSC's support capacity. Coordinated control scheme-III (CCS-III) considers simultaneous disturbances on both the wind turbine and grid side to stabilize the DC-link and grid voltage. The proposed control schemes have been experimentally implemented with a dSpace MicroLabBox. Additionally a Lyapunov function based stability analysis of the system including the SCES is presented in the paper.
30 April 2026 in Applied Soft Computing
MMMohammed Saad Abdelazim Mohammed
Mohammed Saad Abdelazim Mohammed
12 December 2023 in IEEE Transactions on Industry Applications
This article presents the inclusive DC-link voltage control and protection scheme for the DC-link of the microgrid. The proposed inclusive scheme is proposed to control the DClink voltage during load-switching or AC-side faults scenarios, and protect the DC-link when short-circuit fault emerges at DClink. To examine the proposed inclusive scheme, the microgrid test system is created according to the IEEE-1547 standard in PSCAD/EMTDC based software system. Then the designed microgrid is examined under various fault scenarios to confirm the performance of the developed scheme. Results show that the presented control and protection scheme can maintain the DClink voltage under faults on the AC or DC sides in grid-connected and islanding modes of operation. The proposed scheme has the ability to ensure the voltage regulation and protection of the DClink of the microgrid under different operating conditions and faults.
15 July 2022 in IEEE Transactions on Industry Applications
In this paper, two coordinated control schemes have been designed for a grid-connected permanent magnet synchronous generator-based wind energy conversion system with static synchronous compensator (STATCOM) and supercapacitor energy storage (SCES) under various operating conditions. The coordinated control scheme-I (CCS-I) integrated a SCES into the DC-link through a bidirectional DC/DC converter to stabilize the DC-link voltage under varying wind speed and grid disturbances. The coordinated control scheme-II (CCS-II) implemented a STATCOM at the point of common coupling (PCC) to enhance the grid voltage stability during the grid voltage sag or swell. In CCS-II the SCES balances the active power while reactive power support is extracted from the grid side converter (GSC). The STATCOM is only activated when the reactive power requirement by the PCC exceeds the support capacity of the GSC. The proposed coordinated control schemes have been experimentally implemented with a dSpace MicroLabBox. Results show that CCS-I and II ensured the uninterrupted operation of the wind energy system and satisfied grid code requirements under various operating conditions and grid disturbances.