1 March 2020 in Plasma Sources Science and Technology
Effects of microwave frequency on the growth rate of an upstream dielectric multipactor are studied. Our previous research (2018 Plasma Sources Sci. Technol. 27 125006) shows that the growth rate is independent of microwave frequency in a strong microwave. However, this note shows that the growth rate would decrease quickly to a negative value if the microwave frequency increases to be above a critical value (far away from the first crossover point of unit secondary yield). This phenomenon is observed using electromagnetic particle-in-cell simulation on a dielectric exposed to microwaves of TEM modes TE 01 mode, and TE 11 mode, respectively. Consistent simulation results and theoretical results show that the suppression of the multipactor is induced from the returning difficulty of emitted electrons, and the critical microwave frequency corresponding to zero growth rate is in direct proportion to the rf electric field amplitude and is in positive correlation with the secondary electron yield.
1 July 2021 in AIP Advances
The dynamic behaviors of electrons in a miniature Penning ion source model are analyzed by the particle in cell/Monte Carlo collision particle simulation method combined with the scalar magnetic potential finite-difference method. Mainly, the influence of magnetic shielding on the trajectory and spatial distribution of electrons in the discharge process is taken into consideration. The influence of magnetic shielding on the plasma impedance during the excitation discharge of the Penning source is further discussed. The calculated target current is in good agreement with the experimental value. The simulation results show that the addition of magnetic shielding can reduce the fluctuation of electron density, increase the uniformity of electron spatial distribution, and double the plasma impedance stabilization zone, which are beneficial to the stability of the discharge process in the source. However, the magnetic shielding can cause a decrease in the electron density, which limits the plasma ionization degree. The study on magnetic shielding helps to understand the electron dynamics characteristics of the Penning ion source and provides a reference for improving the source performance in the future.
1 June 2018 in Physics of Plasmas
By using the electromagnetic Particle-In-Cell method, the multipactor of the dielectric window on the upstream side is observed directly even without presetting extra normal electric fields and compared to that on the downstream side. This paper shows: First, with the initial emission of electrons to provide extra normal electric fields, the secondary electron avalanche is much faster than that on the downstream side. Second, even without the initial emission of electron to provide extra normal electric fields, the secondary electron avalanche occurs on the upstream side, while it is nowhere to be found on the downstream side.
27 November 2024 in IEEE Transactions on Electron Devices
An electromagnetic particle-in-cell (PIC) simulation technique is used to analyze multipactor discharge on a dielectric with a beat wave composed of multiple high-power microwaves (HPMs) with similar frequencies. Unlike the single-frequency HPM, the strength of $\textit{E}_{\text{n}}$ of the multipactor with a beat wave fluctuates greatly with time, resulting in the root-mean-square value of $\textit{E}_{\text{n}}$ (strongly related to the average deposition power) being significantly greater than the absolute value of the arithmetic mean of $\textit{E}_{\text{n}}$ (the traditional indicator of the multipactor strength), where $\textit{E}_{\text{n}}$ is the electric field due to the deposited charges induced by multipactor. In this article, the influence of double-frequency and triple-frequency beat waves on multipactor is studied from the perspective of the root-mean-square value and absolute value of the arithmetic mean of $\textit{E}_{\text{n}}$ . The results show that the strong multipactor with a beat wave is unaffected by the spectra of the beat wave and the beat wave cannot inhibit the strong multipactor strength in contrast to a single-frequency HPM with the same average microwave power while the inhibition effect of a beat wave on a moderated multipactor is obvious. Further analysis shows that the suppression effect of a beat wave on a moderated multipactor is greatest when both the frequencies and phases of the beat wave are arranged in an arithmetic progression and the moderated multipactor can also be suppressed substantially when the amplitudes of the beat wave deviate slightly from the condition of equal amplitude.
1 January 2012 in Acta Physica Sinica
依据实际器件尺寸, 建立了带螺旋支撑杆的同轴磁绝缘传输线三维数值模拟模型; 选取合适的二极管阴阳极间距作为传输线负载; 设置相应的模拟参数对其进行模拟. 将模拟结果与实验数据进行对比, 证明了模拟的可靠性; 并结合相应的实验数据, 分析了同轴磁绝缘传输线在加入螺旋支撑结构后 对其传输效率的影响.
1 April 2017 in Physics of Plasmas
Based on the 3-dimensional Particle-In-Cell (PIC) code CHIPIC3D, with a new circuit boundary algorithm we developed, a conical magnetically insulated transmission line (MITL) with a 1.0-MV linear transformer driver (LTD) is explored numerically. The values of switch jitter time of LTD are critical parameters for the system, which are difficult to be measured experimentally. In this paper, these values are obtained by comparing the PIC results with experimental data of large diode-gap MITL. By decreasing the diode gap, we find that all PIC results agree well with experimental data only if MITL works on self-limited flow no matter how large the diode gap is. However, when the diode gap decreases to a threshold, the self-limited flow would transfer to a load-limited flow. In this situation, PIC results no longer agree with experimental data anymore due to the anode plasma expansion in the diode load. This disagreement is used to estimate the plasma expansion speed.