A unified theory of multipactor discharge on a dielectric is proposed by utilizing the similarity of the energy balance between multipactor and collisional gas discharge. In this theory, the electron energy gain in multipactor is predicted using the classical formulas for the electric field powers in gas discharge, and the electron energy loss is caused by electron bombardment to the dielectric surface. As with kinetic effects in collisional gas discharge, the electron energy distribution function is important in saturated multipactor. Due to the complex energy distribution functions in saturated multipactor, the average bombardment electron energies are varied and much larger than the traditional predicted value indicated by the first crossover of unity in the secondary electron yield. Using the proposed energy-balance model, multipactor in envelope microwaves and multipactor under an extra magnetic field are both theoretically predicted. The theoretical results for the surface-normal accumulative electric field and the deposited power in saturated multipactor are consistent with the results from electromagnetic particle-in-cell (PIC) simulations.
17 October 2022 in IEEE Transactions on Electron Devices
This article shows that multipactor on a dielectric window exposed to circularly polarized microwave can be suppressed by a proper normal gyromagnetic field, while a normal gyromagnetic field is traditionally considered to strengthen multipactor in a linearly polarized wave. The dc electric field and the deposited power of multipactor in circularly polarized microwave with normal gyromagnetic field are predicted theoretically and validated by particle-in-cell simulations. The results show that the multipactor threshold ${E}_{{0}}$ is about $\pi \vert \omega +\omega _{c} \vert ({m}\varepsilon _{\text {low}}/{(}{8}{e}^{{2}}{)})^{1/2} $ for left-handed circularly polarized waves or $\pi \vert \omega -\omega _{c} \vert ({m}\varepsilon _{\text {low}}/{(}{8}{e}^{{2}}{)})^{1/2} $ for right-handed circularly polarized waves, where ${E}_{{0}}$ is the amplitude of RF electric field, $\omega $ is the angular frequency of RF electric field, $\omega _{c}$ is the cyclotron angular frequency due to the normal magnetic field ${B}$ ( $\omega _{c} > 0$ if ${B}$ is pointing to the surface, while $\omega _{c} < 0$ if ${B}$ is away from the surface), ${m}$ is the electron mass, ${e}$ is the element charge, and $\varepsilon _{\text {low}}$ is the first crossover energy in the unit of secondary electron yield.
21 June 2023 in IEEE Transactions on Microwave Theory and Techniques
The purpose of this article is to solve the issue that current high-power microwave (HPM) transmission links are used in the rigid metal waveguide, which causes significant installation difficulties to the system integration. In this article, we design the TM $_{01}$ and TE $_{01}$ high-power handling corrugated flexible waveguides using a numerical analysis method based on coupled wave theory. The measured results are in good agreement with the numerical calculation method. The designed TM $_{01}$ corrugated flexible waveguide has a transmission efficiency of up to 98% at bending angles less than $\pm$ 5 $^{\circ}$ , and correspondingly, the TE $_{01}$ corrugated flexible waveguide has a transmission efficiency of up to 98% at bending angles less than $\pm$ 8 $^{\circ}$ . The designed flexible waveguides are all capable of power capacities of more than 3 GW.
1 March 2020 in Plasma Sources Science and Technology
Effects of microwave frequency on the growth rate of an upstream dielectric multipactor are studied. Our previous research (2018 Plasma Sources Sci. Technol.27 125006) shows that the growth rate is independent of microwave frequency in a strong microwave. However, this note shows that the growth rate would decrease quickly to a negative value if the microwave frequency increases to be above a critical value (far away from the first crossover point of unit secondary yield). This phenomenon is observed using electromagnetic particle-in-cell simulation on a dielectric exposed to microwaves of TEM modes TE 01 mode, and TE 11 mode, respectively. Consistent simulation results and theoretical results show that the suppression of the multipactor is induced from the returning difficulty of emitted electrons, and the critical microwave frequency corresponding to zero growth rate is in direct proportion to the rf electric field amplitude and is in positive correlation with the secondary electron yield.
The dynamic behaviors of electrons in a miniature Penning ion source model are analyzed by the particle in cell/Monte Carlo collision particle simulation method combined with the scalar magnetic potential finite-difference method. Mainly, the influence of magnetic shielding on the trajectory and spatial distribution of electrons in the discharge process is taken into consideration. The influence of magnetic shielding on the plasma impedance during the excitation discharge of the Penning source is further discussed. The calculated target current is in good agreement with the experimental value. The simulation results show that the addition of magnetic shielding can reduce the fluctuation of electron density, increase the uniformity of electron spatial distribution, and double the plasma impedance stabilization zone, which are beneficial to the stability of the discharge process in the source. However, the magnetic shielding can cause a decrease in the electron density, which limits the plasma ionization degree. The study on magnetic shielding helps to understand the electron dynamics characteristics of the Penning ion source and provides a reference for improving the source performance in the future.
27 November 2024 in IEEE Transactions on Electron Devices
An electromagnetic particle-in-cell (PIC) simulation technique is used to analyze multipactor discharge on a dielectric with a beat wave composed of multiple high-power microwaves (HPMs) with similar frequencies. Unlike the single-frequency HPM, the strength of $\textit{E}_{\text{n}}$ of the multipactor with a beat wave fluctuates greatly with time, resulting in the root-mean-square value of $\textit{E}_{\text{n}}$ (strongly related to the average deposition power) being significantly greater than the absolute value of the arithmetic mean of $\textit{E}_{\text{n}}$ (the traditional indicator of the multipactor strength), where $\textit{E}_{\text{n}}$ is the electric field due to the deposited charges induced by multipactor. In this article, the influence of double-frequency and triple-frequency beat waves on multipactor is studied from the perspective of the root-mean-square value and absolute value of the arithmetic mean of $\textit{E}_{\text{n}}$ . The results show that the strong multipactor with a beat wave is unaffected by the spectra of the beat wave and the beat wave cannot inhibit the strong multipactor strength in contrast to a single-frequency HPM with the same average microwave power while the inhibition effect of a beat wave on a moderated multipactor is obvious. Further analysis shows that the suppression effect of a beat wave on a moderated multipactor is greatest when both the frequencies and phases of the beat wave are arranged in an arithmetic progression and the moderated multipactor can also be suppressed substantially when the amplitudes of the beat wave deviate slightly from the condition of equal amplitude.