20 August 2024 in IEEE Transactions on Electron Devices
The multibeam klystron (MBK) faces the challenge of miniaturization together with stringent requirements for high power and high efficiency (HE) in L -band and below frequency regimes. Inspired by the core stabilization method (CSM), this article proposes three types of hybrid-modes resonant cavities, which can operate simultaneously in two harmonic modes. The large-signal simulation and 3-D particle-in-cell (PIC) simulation results demonstrate that this novel CSM MBK equipped with two hybrid-modes resonant cavities, operating at both fundamental and second harmonics, could provide up to 11.5-MW output power with 65.9% electronic efficiency at a total circuit length of 592 mm. This L -band MBK is launched with six beamlets, of which the beam voltage is 110 kV and the total current is 168 A. Moreover, compared with the MBKs designed by the traditional approach with only fundamental cavities or the CSM approach with individual harmonic cavities, the new hybrid HE klystron proposal exhibits not only decent efficiency performance but also, more importantly, ultracompact dimensions, where the circuit length is significantly shortened by about 45% and 35%, respectively.
1 July 2024 in IEEE Transactions on Electron Devices
In a multibeam klystron (MBK) electron optics system (EOS), the beamlets are significantly offset from the global magnetic central axis, in which the transverse component of the magnetic field in the center of each beamlet causes deviation of the beamlet from its local propagation axis. Therefore, it is mandatory to manipulate the magnetic focusing system to mitigate such impact within an acceptable level. This article proposes a novel theoretical analysis method that can rapidly and accurately evaluate electron beam trajectories, significantly improving the computational efficiency by at least 1 $\sim$ 2 orders of magnitude, compared with the conventional full 3-D simulation approach, thus greatly speeding up the design process of MBK. Furthermore, this method can also be applied to determine sensitivities to manufacturing errors in klystron EOS. These errors can significantly impact the electron beam’s transmission characteristics, making a thorough analysis and evaluation mandatory. The effectiveness of the proposed method is demonstrated via the optimization of a 16-beam $\textit{S}$ -band high-power high-efficiency MBK and manufacturing errors analysis of $\textit{C}$ -band high-power high-efficiency single beam klystron (SBK).
26 March 2024 in IEEE Transactions on Electron Devices
In klystron amplifiers, spurious oscillations caused by the backstreaming electrons from collector may lead to unacceptable instabilities in experiments. To facilitate the fast and accurate analysis of such types of self-oscillations, rather than performing time-consuming particle-in-cell (PIC) simulations, the small signal theory to predict threshold conditions of spurious oscillations in klystrons has been further developed and implemented into the klystron computer code KlyC. If spurious oscillation occurs, the frequency and Q of the oscillation mode in a small signal regime can also be predicted. The effectiveness of the proposed threshold prediction method has been demonstrated through benchmarking against PIC codes, showing great agreement with result discrepancies at the several percentage level, while numerical computation time for small signal models is significantly (at least three orders of magnitude) faster than executed in the PIC simulations.
23 August 2024 in IEEE Electron Device Letters
During the test of an S-band multibeam klystron (MBK) resonant cavity, an interesting experimental phenomenon was observed: the measured ohmic quality factor ( Q 0 ) of the cavity was surprisingly low (around 200, design value of 5090). This prompted an in-depth investigation, revealing that the low Q 0 was due to the presence of a small gap on the perimeter of the resonant cavity, which resulted from an inadvertent mechanical design. The topology of this assembly gap was similar to an extremely thin coaxial line. To further investigate the impact of such assembly gap, theoretical and numerical models were developed to quantitatively analyze the effect of concentric/eccentric assembly gap on the cavity Q 0 , field asymmetry, the shunt impedance, mode competition, etc. The analysis indicates that the primary factor affecting Q 0 is the length of the small gap. The concentricity and width mainly influence the symmetry and shunt impedance, respectively. The analysis showed good agreement with the experimental results. Based on the above findings, a new approach was proposed to conveniently reduce the Q 0 of the resonant cavity via employing an appropriately long, relatively narrow gap (1/1000 of its radii, to ensure concentricity even in the worst scenario), thereby facilitating the development of broadband klystrons.
22 November 2024 in IEEE Transactions on Electron Devices
In order to overcome the low efficiency (usually less than 25%) of millimeter-wave and terahertz (MMW/THz) klystrons, an exploratory study is conducted to improve the efficiency in the design of W -band extended interaction klystrons (EIKs). In this article, fast large-signal simulations using KlyC code are comprehensively used for the first time to accurately conduct full-scale parameterization of EIK, it is found that the upper limit of terahertz klystron efficiency is no longer solely dominated via the beam perveance, but rather restricted by various factors, including effective impedance, ohmic loss, cavity arrangement, and so on. The physical mechanism involved is so complex that the preliminary parametric sortation is mandatory to achieve very high efficiency (HE). Particle-in-cell (PIC) simulation results verified our theoretical evaluations, demonstrating that the W -band EIK proposed and optimized in this article could deliver up to 44.5% electronic efficiency and 39.2% RF efficiency around 100 GHz, with operating beam voltage of 50 kV and beam current of 2 A. The output power and saturation gain could achieve 39.2 kW and 65.5 dB, respectively, in which no instability is observed. In addition, a novel beam optics system (BOS) based on hybrid permanent magnets is proposed. Such compact BOS is exclusively developed to deal with the challenge induced by severe radial beam expansion in this EIK, which is the side-effect of the high intensity of beam-wave interactions. This study on high-power (HP) HE compact W -band EIK reveals the true potential of such types of devices in the MMW/THz regime.
1 December 2025 in IEEE Electron Device Letters