1 July 2008 in Japanese Journal of Applied Physics
1 January 2014 in MATERIALS TRANSACTIONS
In manufacturing process of semiconductor, blue light emitting diode (LED), and lithium ion battery, detection and monitoring of trace water vapor (<1 µmol/mol) are significantly important techniques. We have been researching about detection of trace water vapor with high speed and sensitivity by using ball surface acoustic wave (SAW) sensor. In this paper, we tried to detect trace water vapor by coating silicon oxide (SiOx) on ball SAW sensor using sol–gel method. It was confirmed that SiOx-coated ball SAW sensor could detect water vapor in a wide range from −95 to 0°C in frost point (0.035–6.0 × 103 µmol/mol in concentration) and its response time to frost point change from −70 to −60°C was one half of that of a chilled-mirror hygrometer.
1 November 2004 in Insight - Non-Destructive Testing and Condition Monitoring
30 May 2022 in Japanese Journal of Applied Physics
For on-site analysis of surface materials on the Moon, planets, and small bodies and for the monitoring of air quality in crewed spacecraft, we have developed a portable gas chromatograph (GC) equipped with a ball surface acoustic wave (SAW) sensor. In this study, we fabricated a 10 cm cube GC that implements the forward flush method using two metal micro-electro-mechanical-system columns coated with different stationary phases in microchannels fabricated by wet etching and diffusion bonding of stainless-steel plates. Using this GC, we succeeded in analyzing 10 kinds of gas within 10 min. In addition, for the application of the ball SAW GC on the ground, we also developed a palm-sized GC with a single metal capillary column and used it in the analysis of the headspace gas of sake. We showed that the ratio of peak areas differed among odorants depending on the brand and brewing process of sake.
1 February 2026 in Review of Scientific Instruments
Most portable gas chromatographs (GCs) were designed exclusively for gas samples. If they can handle liquid samples too, the range of application is expected to expand substantially. However, in general, the injection volume of liquid samples in GCs is limited to about 1 μl or less to prevent the loss of analytical precision and instrument contamination. Therefore, it is difficult to achieve sufficient sensitivity with the limited resources of the portable GCs. In this study, we developed a large volume injection (LVI) technique applicable to portable GCs, fabricated a compact LVI–GC using a spherical surface acoustic wave (SAW) sensor (the ball SAW sensor) as the detector, and confirmed its basic operation. Using a sample mixture of linear alkanes with 7–13 carbons in a pentane solvent, we evaluated measurement conditions without the loss of analyte in a sample volume range of ∼5–50 μl and confirmed the linearity of the response with respect to the sample volume. In addition, 1,2-methylenedioxybenzene, a simulant of a hallucinogen, 3,4-methylenedioxymethamphetamine (MDMA), was analyzed for an application in drug analysis in urine, and a detection limit of ∼23 ng/ml, well below the cutoff value of ∼250 ng/ml for MDMA, was achieved. Furthermore, we found a correlation between the response of the ball SAW sensor and the retention index and investigated the possibility of quantitative analysis using retention indices.