28 May 2020 in IEEE Signal Processing Letters
In this paper, we consider channel estimation for intelligent reflecting surface (IRS)-assisted millimeter wave (mmWave) systems, where an IRS is deployed to assist the data transmission from the base station (BS) to a user. It is shown that for the purpose of joint active and passive beamforming, the knowledge of a large-size cascade channel matrix needs to be acquired. To reduce the training overhead, the inherent sparsity in mmWave channels is exploited. By utilizing properties of Katri-Rao and Kronecker products, we find a sparse representation of the cascade channel and convert cascade channel estimation into a sparse signal recovery problem. Simulation results show that our proposed method can provide an accurate channel estimate and achieve a substantial training overhead reduction.
16 October 2020 in IEEE Transactions on Vehicular Technology
Millimeter wave (MmWave) communications is capable of supporting multi-gigabit wireless access thanks to its abundant spectrum resource. However, severe path loss and high directivity make it vulnerable to blockage events, which can be frequent in indoor and dense urban environments. To address this issue, in this paper, we introduce intelligent reflecting surface (IRS) as a new technology to provide effective reflected paths to enhance the coverage of mmWave signals. In this framework, we study joint active and passive precoding design for IRS-assisted mmWave systems, where multiple IRSs are deployed to assist the data transmission from a base station (BS) to a single-antenna receiver. Our objective is to maximize the received signal power by jointly optimizing the transmit precoding vector at the BS and the phase shift parameters used by IRSs for passive beamforming. Although such an optimization problem is generally non-convex, we show that, by exploiting some important characteristics of mmWave channels, an optimal closed- orm solution can be derived for the single IRS case and a near-optimal analytical solution can be obtained for the multi-IRS case. Our analysis reveals that the received signal power increases quadratically with the number of reflecting elements for both the single IRS and multi-IRS cases. Simulation results are included to verify the optimality and near-optimality of our proposed solutions. Results also show that IRSs can help create effective virtual LOS paths and thus substantially improve robustness against blockages in mmWave communications.
12 May 2023 in IEEE Transactions on Wireless Communications
Integrating sensing functionalities is envisioned as a distinguishing feature of next-generation mobile networks, which has given rise to the development of a novel enabling technology – Integrated Sensing and Communication (ISAC) . Portraying the theoretical performance bounds of ISAC systems is fundamentally important to understand how sensing and communication functionalities interact (e.g., competitively or cooperatively) in terms of resource utilization, while revealing insights and guidelines for the development of effective physical-layer techniques. In this paper, we characterize the fundamental performance tradeoff between the detection probability for target monitoring and the user’s achievable rate in ISAC systems. To this end, we first discuss the achievable rate of the user under sensing-free and sensing-interfered communication scenarios. Furthermore, we derive closed-form expressions for the probability of false alarm (PFA) and the successful probability of detection (PD) for monitoring the target of interest, where we consider both communication-assisted and communication-interfered sensing scenarios. In addition, the effects of the unknown channel coefficient are also taken into account in our theoretical analysis. Based on our analytical results, we then carry out a comprehensive assessment of the performance tradeoff between sensing and communication functionalities. Specifically, we formulate a power allocation problem to minimize the transmit power at the base station (BS) under the constraints of ensuring a required PD for perception as well as the communication user’s quality of service requirement in terms of achievable rate. It indicates that, on the one hand, there exists an intrinsic tradeoff between sensing and communication performance under the mutual-interfered scenarios; On the other hand, with prior knowledge of the baseband waveform, these two functionalities might mutually assist each other to enhance the performance. Finally, simulation results corroborate the accuracy of our theoretical analysis and the effectiveness of the proposed power allocation solutions showing the advantages of the ISAC system over the conventional radar and communication coexistence counterpart.
14 April 2021 in IEEE Transactions on Neural Networks and Learning Systems
In this article, anomaly detection is considered for hyperspectral imagery in the Gaussian background with an unknown covariance matrix. The anomaly to be detected occupies multiple pixels with an unknown pattern. Two adaptive detectors are proposed based on the generalized likelihood ratio test design procedure and ad hoc modification of it. Surprisingly, it turns out that the two proposed detectors are equivalent. Analytical expressions are derived for the probability of false alarm of the proposed detector, which exhibits a constant false alarm rate against the noise covariance matrix. Numerical examples using simulated data reveal how some system parameters (e.g., the background data size and pixel number) affect the performance of the proposed detector. Experiments are conducted on five real hyperspectral data sets, demonstrating that the proposed detector achieves better detection performance than its counterparts.
3 June 2019 in IEEE Transactions on Signal Processing
This paper explores multicarrier waveforms to improve the spectrum efficiency of radar and communication systems that cooperatively coexist in the same bandwidth. We propose two joint design paradigms based on sharing and allocation, respectively. The allocation-based design brings in the advantage of interference avoidance and easy implementation, while the sharing-based joint design offers additional gain in spectrum efficiency. For both design paradigms, the communication throughput is maximized under a minimum signalto- interference-plus-noise ratio (SINR) constraint for the radar along with power constraints. The sharing-based design involves non-convex optimization, which is solved via an alternating direction sequential convex programming (AD-SCP) approach. Meanwhile, the allocation-based design is a mixed integer nonlinear optimization problem, which is solved by the optimum but computationally prohibitive branch and bound (BB) algorithm, as well as a suboptimum penalized sequential convex programming (P-SCP) method. Numerical results show that the proposed joint design paradigms significantly improve the spectrum efficiency over a conventional greedy search (GS) based allocation scheme.
27 June 2018 in IEEE Signal Processing Letters
We consider the nonlinear robust filtering problem where the measurements are partially disturbed by outliers. A new robust Kalman filter based on a detect-and-reject idea is developed. To identify and exclude outliers automatically, each measurement is assigned an indicator variable, which is modeled by a beta-Bernoulli prior. The mean-field variational Bayesian method is then utilized to estimate the state of interest as well as the indicator in an iterative manner at each time instant. Simulation results reveal that the proposed algorithm outperforms several recent robust solutions with higher computational efficiency and better accuracy.