Qing Yang

Qing Yang

Auto-generated profile, based on publicly available information

Qing Yang

School of Automotive Engineering, Wuhan University of Technology, Wuhan 430070, China

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 May 2019 in Polymers
Verified
Journal Article
Open access
PDF file
Wei GuoWei Guo
Wei Guo
QYQing Yang
Qing Yang
HMHuajie Mao
Huajie Mao
Zhenghua MengZhenghua Meng
Zhenghua Meng
Lin HuaLin Hua
Lin Hua
BHBo He
Bo He
A combined in-mold decoration and microcellular injection molding (IMD/MIM) method by integrating in-mold decoration injection molding (IMD) with microcellular injection molding (MIM) was proposed in this paper. To verify the effectiveness of the IMD/MIM method, comparisons of in-mold decoration injection molding (IMD), conventional injection molding (CIM), IMD/MIM and microcellular injection molding (MIM) simulations and experiments were performed. The results show that compared with MIM, the film flattens the bubbles that have not been cooled and turned to the surface, thus improving the surface quality of the parts. The existence of the film results in an asymmetrical temperature distribution along the thickness of the sample, and the higher temperature on the film side leads the cell to move toward it, thus obtaining a cell-offset part. However, the mechanical properties of the IMD/MIM splines are degraded due to the presence of cells, while specific mechanical properties similar to their solid counterparts are maintained. Besides, the existence of the film reduces the heat transfer coefficient of the film side so that the sides of the part are cooled asymmetrically, causing warpage.

7 February 2020 in Polymers
Verified
Journal Article
Open access
PDF file
KYKui Yan
Kui Yan
Wei GuoWei Guo
Wei Guo
HMHuajie Mao
Huajie Mao
QYQing Yang
Qing Yang
Zhenghua MengZhenghua Meng
Zhenghua Meng
A combined in-mold decoration and microcellular injection molding (IMD/MIM) method has been used in this paper. The foamed PP/nano-CaCO3 composites were prepared to investigate their mechanical properties, cellular structure, and surface quality. The content of nano-CaCO3 varied from 0 to 10 wt %. The results showed that nano-CaCO3 acted as a reinforcing phase and nucleating agent, which help to improve the mechanical properties of foamed composites. The cellular structure and mechanical properties were optimum when the nano-CaCO3 content was 6 wt %. In the vertical section, the cell size and density of transition layer on the film side was bigger than that on the non-film side. In the parallel section, the cell ratio of length to diameter of transition layer on the film side was smaller than that on the non-film side, and the cell tile angle was larger than that on the non-film side. With nano-CaCO3 content increasing, the surface quality showed a trend of decreasing first and then increasing.