1 December 2021 in Physica Scripta
An assessment of the tritium (T) inventory in plasma facing components (PFC) during JET T and deuterium-tritium (DT) operations is presented based on the most comprehensive ex situ fuel retention data set on JET PFCs from the 2015-2016 ILW3 operating period is presented. The global fuel retention is 4.19 × 1023 D atoms, 0.19% of injected fuel. The inner divertor remains the region of highest fuel retention (46.5%). The T inventory in PFCs at the end of JET operations is calculated as 7.48 × 1022 atoms and is informative for accountancy, clean-up efficacy and waste liability assessments. The T accumulation rate at the upper inner divertor during JET DT operations has been used to assess the requirements and frequency of operation of a new laser induced desorption diagnostic to be installed on JET for the final DT experiments in 2023.
1 August 2017 in Nuclear Materials and Energy
Divertor tiles removed after the second JET ITER-Like Wall campaign 2013–2014 (ILW-2) were studied using Secondary Ion Mass Spectrometry (SIMS). Measurements show that the thickest beryllium (Be) dominated deposition layers are located at the upper part of the inner divertor and are up to ∼40µm thick at the lower part of Tile 0 exposed in 2011–2014. The highest deuterium (D) amounts (>8 · 1018at./cm2), in contrast, were found on the upper part of Tile 1 (2013–2014), where the Be deposits are ∼10µm thick. D was mainly retained in the near-surface layer of the Be deposits but also deeper in tungsten (W) and molybdenum (Mo) layers of the marker coated tiles, especially at W–Mo layer interfaces. D retention for the ILW-2 divertor tiles is higher than for the first campaign 2011–2012 (ILW-1) and probable reasons for the difference are that SIMS measurements for the ILW-2 samples were done deeper than for the ILW-1 samples, some of the tiles were exposed during both ILW-1 and ILW-2 and therefore had a longer exposure time, and the differences between ILW-1 and ILW-2 campaigns e.g. in strike point distributions and injected powers
30 December 2009 in Physica Scripta
1 December 2009 in Journal of Nuclear Materials
1 December 2008 in Fusion Engineering and Design