A linear multi-degree-of-freedom piezoelectric energy harvester has been designed in this paper. The proposed energy harvester was comprised by multi-order transmission beams and traditional single cantilever beam. As the transmission beam order increases, the resonant frequencies of this kind of harvester could be tuned and reduced efficiently. The first three modes of the three-degree-of-freedom harvester occur within the range of 0-100 Hz, reaching a fair agreement with the simulation. The operating bandwidth expands to 15 Hz, 375% of the conventional piezoelectric cantilever beam, which made this designed harvester a good candidate for energy scavenging in multi-sources and wide-frequency vibration environment.
A neat 3*5 element energy harvester array exploiting multiple vibration modes separation technique, has been designed, fabricated, and characterized. A considerable wideband of 15.6 Hz at simulation and 13 Hz at experiment has been gained in a very low frequency range (below 50 Hz), with the acceleration of 1g. Experimental results show that the adjusted harvester could generate the output power of about 2.1 mW at an 8 Hz resonant frequency with the optimum load resistance 350 kΩ. Meanwhile, the half-power (1.05 mW) bandwidth could reach up to 15.3 Hz. These results enable the designed device to improve viability for power supply of low power micro electron devices in some special low frequency vibration environment, such as large engineering applications, bridge monitoring, and wildlife monitoring.
Tungsten disulfide (WS 2 ) is emerging with dazzling visibility as a “layered material beyond graphene and molybdenum disulfide” due to its exquisite tunable electronic, surface structure, high carrier mobility and physicochemical stability. In this paper, In 2 O 3 and Au nanoparticles (NPs) co-modified WS 2 microsheets were prepared for detecting NO 2 at room temperature (RT). The In 2 O 3 and Au NPs were anchored on the surface of WS 2 microsheets, which could be observed by the characterization. The NO 2 sensing performance at RT was optimized by adjusting the contents of In 2 O 3 and Au NPs. The proposed gas sensor based on Au 1 WIn 6 (WS 2 microsheets co-modified with 6 wt% In 2 O 3 and 1 wt% Au NPs) showed the highest response (46.91 to 50 ppm NO 2 ), low theoretical detection of limit (LOD, 18.9 ppb), excellent linearity within the test range, and good stability under various relative humidity (RH), bending degrees and bending times. The excellent result is attributed to the formation of a heterojunction, which increases the number of ionised oxygen adsorption sites and facilitates the reaction between NO 2 gas and Au 1 WIn 6 . Therefore, it is believed that decorating WS 2 microsheets with metal oxide and noble metal NPs is a promising strategy to improve the NO 2 sensing property at RT.