This study aimed to understand and establish changes in the physicochemical properties of yam powder with different processing methods, and select a suitable method for use in the development of hypoglycemic functional foods. Samples were dried using three methods, namely hot air drying, vacuum freeze drying, and microwave vacuum drying, and turned to powder using two smashing methods, namely ordinary smashing and superfine smashing (SS). Color changes, polarized light microscopy, differential scanning calorimetry, X-ray diffraction, polysaccharide dissolution rates, α-glucosidase inhibitory activities, glucose dialysis retardation indexes, and digestive characteristics were measured. The results showed that the drying method and the smashing method had significantly different effects on the physicochemical properties and digestion characteristics of the yam powder. Freeze-dried yam retained more nutrients, while SS increased the rapidly digestible starch content, reduced the digestible starch and resistant starch contents, and increased the polysaccharide dissolution rate in the yam powder samples. Six samples were compared using principal component analysis, with the highest composite score observed for the samples treated by freeze drying coupled with SS, followed by hot-air drying coupled with superfine smashing (HAO).
Silicon Photomultipliers (SiPM) has become more and more important in many fields. In practical applications, its surface needs to be covered with passivation protective layer and anti-reflection coating. The usual practice is to cover the protective layer on the anti-reflection coating. However, the upper protective layer will change the anti-reflection effect. We studied the effect of SiPM surface coverage protective material on its light response characteristics. The simulation result showed that when the surface of SiPM device has SiO2 anti-reflection coating and silicon resin protective layer, the reflection light can be reduced by 27% and the photocurrent can be increased by 20% in the visible and near-infrared wavelength range. When the wavelength of light is 905 nm and the thickness of silicon resin changes in the range of 100 ~ 300 microns, the surface light reflectivity of the device can be reduced from 33% of bare silicon to 5.8% ~ 8.9%. Finally, the transmission spectrum of the double-layer medium composed of a glass slide with a main component of a SiO2 slice and a silicon resin coating was tested. The experimental results showed that the light transmittance of the double-layer coating system in the visible region increased by about 20% after the addition of silicon resin. The experimental results are basically consistent with the simulation results. This shows that the SiPM surface protective coating layer can effectively reduce the reflected light on the surface of the device and further achieve the effect of anti-reflection.
Optical coherence tomography (OCT) is a new biomedical imaging technique in resent year. It has some good qualities, such as non-ionizing radiation, non-invasive, high resolution and sensitivity. High-speed OCT imaging is very important for obtaining the cross-sectional images of the internal microstructure of living tissue. Increasing the imaging speed can produce imaging real time. To study high speed OCT, a new method of OCT imaging technique has been designed in this paper--replacing the point-focus mode with line-focus mode in the sample arm. Cylindrical lens can be used for focusing the incident light into a line in the sample. And a 2D OCT imaging can be obtained in one dimension scanning. In the paper we analyze the interference principle of line-focus imaging mode.