12 January 2018 in Sports Biomechanics
Athletes in inner lanes may be disadvantaged during athletic sprint races containing a bend portion because of the tightness of the bend. We empirically investigated the veracity of modelled estimates of this disadvantage and the effect of running lane on selected kinematic variables. Three-dimensional video analysis was conducted on nine male athletes in lanes 8, 5 and 2 of the bend of an outdoor track (radii: 45.10, 41.41 and 37.72 m, respectively). There was over 2% (p < 0.05) reduction in mean race velocity from lane 8 (left step 9.56 ± 0.43 m/s, right step: 9.49 ± 0.41 m/s) to lane 5 (left step: 9.36 ± 0.51 m/s, right step: 9.30 ± 0.51 m/s), with only slight further reductions from lane 5 to lane 2 (left step: 9.34 ± 0.61 m/s, right step: 9.30 ± 0.63 m/s). Race velocity decreased mainly because of reductions in step frequency as radius decreased. These unique data demonstrate the extent of the disadvantage of inner lane allocation during competition may be greater than previously suspected. Variations in race velocity changes might indicate some athletes are better able to accommodate running at tighter radii than others, which should have implications for athletes’ training.
27 May 2019 in Scandinavian Journal of Medicine & Science in Sports
3 December 2019 in Journal of Sports Sciences
A decrease in speed when sprinting on the bend compared with the straight has been attributed to kinetic, kinematic and spatiotemporal modifications. Although maximal speed is dependent on an athlete’s ability to accelerate, there is limited research investigating the acceleration phase of bend sprinting. This study used a lower limb and trunk marker set with 15 optoelectronic cameras to examine kinematic and spatiotemporal variables of the lower limb during sprinting on the bend and straight. Nine sprinters completed up to six 30 m maximal effort trials in bend (radius 36.5 m, lane one) and straight conditions. An increase in body lateral lean at touchdown resulted in a number of asymmetric kinematic modifications. Whilst the left limb demonstrated a greater peak hip adduction, peak hip internal rotation and peak ankle eversion on the bend compared with the straight, the right limb was characterised by an increase in peak hip abduction. These results demonstrate that kinematic modifications start early in the race and likely accumulate, resulting in greater modifications at maximal speed. It is recommended that strength and conditioning programmes target the hip, ankle and foot in the non-sagittal planes. In addition, sprint training should prioritise specificity by occurring on the bend.
1 March 2020 in Journal of Biomechanics
2 October 2018 in Sports Biomechanics
Sprint velocity decreases on the bend when compared with the straight, therefore understanding technique during bend sprinting could have important implications for aiding race performance. Few bend sprinting studies have used optoelectronic cameras to investigate kinematic variables. Limited published evidence regarding the reliability of marker sets in conditions representative of elite bend sprinting makes model selection difficult. Therefore, a test-retest protocol was conducted to establish the reliability and minimum detectable difference of a lower limb and trunk marker set during bend sprinting (radius: 36.5 m). Six participants completed five, 60 m trials at maximum effort, with data collected at 38–45 m. This was repeated 2–7 days later. Spatio-temporal (e.g., contact time) and kinematic variables (e.g., peak joint angles) were evaluated. Intra-class correlation coefficients (ICC) were used to determine the between- and within-day reliability. Between-day reliability (ICC 3, k) was fair to excellent for all variables. Compared to between-day, within-day reliability demonstrated stronger agreement for the majority of variables. Thus, same-day data collection is preferable. It has been established that the marker set is reliable for future use. In addition, the minimal detectable difference was calculated which serves as useful reference for future research in bend sprinting
16 November 2021 in Sports Biomechanics
Athletes use either an eight-step or a seven-step strategy to reach the first hurdle in the 110 m hurdles event. This study investigates the effect of step strategy on the hurdle clearance technique and spatio-temporal parameters of the four steps prior to hurdle clearance. Two-dimensional video data were collected in the sagittal plane from 12 male sprinters, grouped as seven-step (n = 6) or eight-step (n = 6) strategists. The take-off distance was 0.20 m further from the hurdle and the touchdown was 0.42 m closer to the hurdle for seven-step athletes. Additionally, seven-step athletes reduced the length of the final step before hurdle take-off by 0.14 m compared with the previous step, whereas the eight-step athletes extended their final step by 0.17 m. There was negligible difference between the mean horizontal velocities of the two groups throughout the hurdle clearance (0.02 m/s) or the approach time to the first hurdle from the block clearance (0.01 s). This presents an important first insight into the effect of the step strategy on the first hurdle kinematics. Our findings identify the take-off and touchdown distance parameters of the hurdle clearance technique, and approach step characteristics for a successful seven- or eight-step approach strategy to be employed.