Kevin M. K. H. Leong

Kevin M. K. H. Leong

Auto-generated profile, based on publicly available information

Kevin M. K. H. Leong

Northrop Grumman Corporation, Redondo Beach, CA, USA

Research Focus & Metrics

Academic Career Length

25Years (2002-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
26 May 2021 in IEEE Transactions on Terahertz Science and Technology
Verified
Journal Article
Closed access
CCCaitlyn M. Cooke
Caitlyn M. Cooke
KLKevin M. K. H. Leong
Kevin M. K. H. Leong
AZAlexis Zamora
Alexis Zamora
BGBen S. Gorospe
Ben S. Gorospe
GMGerry X. B. Mei
Gerry X. B. Mei
WDWilliam R. Deal
William R. Deal
In this work, a novel 670-GHz integrated direct-detection receiver using 25-nm InP HEMT technology is presented. This is the first demonstration of an integrated direct-detection radiometer architecture at these frequencies. The receiver exhibits a noise figure of 11.4 dB with a total dc power consumption of 0.25 W. The integrated receiver measures only 0.8 cm × 1.3 cm × 4.8 cm (0.3” × 0.5” × 1.9”). These results show that transistor-based direct-detection receivers are a viable technology for submillimeter-wave applications, with low SWaP with no compromise in performance.

1 May 2010
Verified
Conference Paper
Closed access
VRV. Radisic
V. Radisic
KLK. M. Leong
K. M. Leong
XMX. Mei
X. Mei
SSS. Sarkozy
S. Sarkozy
WYW. Yoshida
W. Yoshida
WDW. R. Deal
W. R. Deal
In this paper, a 220 GHz solid-state power amplifier (SSPA) module is presented. Eight-way on-chip power combining is used to achieve a saturated output power ≥ 50 mW over a 217.5 to 220 GHz bandwidth, representing a significant increase in SSPA output power at this frequency compared to prior state of the art. The amplifier MMIC is implemented in coplanar waveguide (CPW) technology and uses sub 50 nm InP HEMT transistors. Two levels of power combining, a 2∶1 tandem coupler and a 4∶1 Dolph-Chebychev transformer, are realized in CPW. The module demonstrates ≥ 11.5 dB small signal gain from 207 to 230 GHz. Saturated output power ≥ 40 mW was measured from 216 to 222.5 GHz.

1 June 2006
Verified
Conference Paper
Closed access
CLCheng-Jung Lee
Cheng-Jung Lee
KLKevin M. K. H. Leong
Kevin M. K. H. Leong
TITatsuo Itoh
Tatsuo Itoh
This paper presents a methodology of designing a microwave bandstop filter and a bandpass filter by using a Composite Right/Left Handed transmission line (CRLH-TL) as part of a transversal filter. The CRLH-TL can be engineered to have specific phase slope and phase offset. Connecting the CRLH-TL and the conventional microstrip delay line at both input and output can establish a transversal filter where the signal merging at the output has broadband out of phase characteristics. Therefore, the bandstop filter can be created with signal rejection over a wide frequency range. The measured 3dB bandwidth of the bandstop filter is 130% and the minimum insertion loss at the next passband is -1.7dB. In addition, based on the bandstop filter a bandpass filter with a wide signal rejection range is developed by creating a frequency dependent defect in one branch of the bandstop filter. This is implemented by either attaching a microstrip open stub or capacitively coupling a microstrip resonator to the microstrip delay line. The 3dB passband bandwidth and the minimum insertion loss are 18%, -1.5dB and 8%, -2dB corresponding to the open stub and the resonator scheme, respectively

25 October 2019 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
CCCaitlyn M. Cooke
Caitlyn M. Cooke
KLKevin M. K. H. Leong
Kevin M. K. H. Leong
AEAlfonso Escorcia
Alfonso Escorcia
KNKhanh Nguyen
Khanh Nguyen
XMXiao Bing Mei
Xiao Bing Mei
WDWilliam R. Deal
William R. Deal
In this article, a 220-GHz direct detection polarimetric receiver is reported. This polarimetric receiver is intended for sensing of the microphysical properties of cloud ice in the earth's upper atmosphere. In the article, we report the measured RF performance, including RF gain of approximately 35 dB per channel and integrated noise figure of the receiver. The noise figure is measured to be 5.1 dB for the horizontally polarized channel and 5.4 dB for the vertically polarized channel. The receiver measures only 1.8 cm × 3.0 cm × 6.4 cm and has a total regulated dc power consumption of 520 mW. This article represents the first 220-GHz polarimetric direct detection receiver and is enabled by an advanced 25-nm indium phosphide (InP) HEMT monolithic microwave integrated circuit (MMIC) technology.

1 October 2015
Verified
Conference Paper
Closed access
KLK. Leong
K. Leong
XMX. B. Mei
X. B. Mei
WYW. Yoshida
W. Yoshida
MLM. Lange
M. Lange
AZA. Zamora
A. Zamora
WDW. R. Deal
W. R. Deal
In the paper, we report on recent progress in scaling InP HEMT MMIC technology to Submillimeter (SMMW) and Terahertz (THz) frequencies. We show that amplification has reached 0.85 THz, with low noise and power amplification in packaged amplifiers at this frequency. Moreover, we show that the entire receiver and exciter function, including mixing and frequency multiplication can be accomplished in the same technology.

13 November 2002
Verified
Conference Paper
Closed access
KLK.M.K.H. Leong
K.M.K.H. Leong
YQYongxi Qian
Yongxi Qian
TIT. Itoh
T. Itoh