1 November 2007 in Genetics
SHSybil A Herrera-Foessel
+7
Linkage disequilibrium can be used for identifying associations between traits of interest and genetic markers. This study used mapped diversity array technology (DArT) markers to find associations with resistance to stem rust, leaf rust, yellow rust, and powdery mildew, plus grain yield in five historical wheat international multienvironment trials from the International Maize and Wheat Improvement Center (CIMMYT). Two linear mixed models were used to assess marker–trait associations incorporating information on population structure and covariance between relatives. An integrated map containing 813 DArT markers and 831 other markers was constructed. Several linkage disequilibrium clusters bearing multiple host plant resistance genes were found. Most of the associated markers were found in genomic regions where previous reports had found genes or quantitative trait loci (QTL) influencing the same traits, providing an independent validation of this approach. In addition, many new chromosome regions for disease resistance and grain yield were identified in the wheat genome. Phenotyping across up to 60 environments and years allowed modeling of genotype × environment interaction, thereby making possible the identification of markers contributing to both additive and additive × additive interaction effects of traits.
1 January 2015 in Crop Science
Genomic selection incorporates all the available marker information into a model to predict genetic values of breeding progenies for selection. The objective of this study was to estimate genetic gains in grain yield from genomic selection (GS) in eight bi‐parental maize populations under managed drought stress environments. In each population, 148 to 300 F2:3 (C0) progenies were derived and crossed to a single‐cross tester from a complementary heterotic group. The resulting testcrosses of each population were evaluated under two to four managed drought stress and three to four well‐watered conditions in different locations and genotyped with 191 to 286 single nucleotide polymorphism (SNP) markers. The top 10% families were selected from C0 using a phenotypic selection index and were intermated to form C1. Selections both at C1 and C2 were based on genomic estimated breeding values (GEBVs). The best lines from C0 were also advanced using a pedigree selection scheme. For genetic gain studies, a total of 55 entries representing the eight populations were crossed to a single‐cross tester, and evaluated in four managed drought stress environments. Each population was represented by bulk seed containing equal amounts of seed of C0, C1, C2, C3, parents, F1s, and lines developed via pedigree selection. Five commercial checks were included for comparison. The average gain from genomic selection per cycle across eight populations was 0.086 Mg ha–1. The average grain yield of C3–derived hybrids was significantly higher than that of hybrids derived from C0. Hybrids derived from C3 produced 7.3% (0.176 Mg ha–1) higher grain yield than those developed through the conventional pedigree breeding method. The study demonstrated that genomic selection is more effective than pedigree‐based conventional phenotypic selection for increasing genetic gains in grain yield under drought stress in tropical maize.
12 July 2009 in Theoretical and Applied Genetics
7 December 2007 in Euphytica
Despite QTL mapping being a routine procedure in plant breeding, approaches that fully exploit data from multi-trait multi-environment (MTME) trials are limited. Mixed models have been proposed both for multi-trait QTL analysis and multi-environment QTL analysis, but these approaches break down when the number of traits and environments increases. We present models for an efficient QTL analysis of MTME data with mixed models by reducing the dimensionality of the genetic variance–covariance matrix by structuring this matrix using direct products of relatively simple matrices representing variation in the trait and environmental dimension. In the context of MTME data, we address how to model QTL by environment interactions and the genetic basis of heterogeneity of variance and correlations between traits and environments. We illustrate our approach with an example including five traits across eight stress trials in CIMMYT maize. We detected 36 QTLs affecting yield, anthesis-silking interval, male flowering, ear number, and plant height in maize. Our approach does not require specialised software as it can be implemented in any statistical package with mixed model facilities.
1 December 2007 in Crop Science
1 March 2012 in Field Crops Research