Highly active metal nanoparticle (MNP) supported cellulose nanofiber (CNF) composites (Au/CNF, Ni/CNF and Ag/CNF) were prepared for the reduction of 4- and 2-nitrophenols (4-NP and 2-NP) in water. Transmission electron microscopy (TEM) images showed that the ultrafine nanoparticles (Au, Ni and Ag NPs) were uniformly deposited on CNFs surface. The content of Au (9.7 wt%), Ni (21.5 wt%) and Ag (22.6 wt%) in Au/CNF, Ni/CNF and Ag/CNF respectively was determined by energy dispersive spectroscopy (EDS) and inductive coupled plasma-mass spectroscopy (ICP-MS) analysis. The chemical state of the MNPs in Au/CNF, Ni/CNF and Ag/CNF was determined by X-ray photoelectron spectroscopy (XPS) and X-ray diffraction (XRD). The significant metal-support interaction was studied by means of XPS. The Au/CNF, Ni/CNF and Ag/CNF demonstrated excellent catalytic activity towards the reduction of nitrophenols to aminophenols in water. To our delight, even a very low amount of catalyst was also found to be good enough to achieve 100% reduction of 4- and 2-NP with a higher reaction rate (within 5 min). The best rate constant (kapp) values were determined for the cellulose nanocomposites. To the best our knowledge, Au/CNF, Ni/CNF and Ag/CNF are the most efficient nanocatalysts for the reduction of 4- and 2-NP reported to date. The catalytic performance of Au/CNF, Ni/CNF and Ag/CNF was compared with previously reported results. A possible mechanism has been proposed for these catalytic systems.
18 July 2024 in Journal of the American Chemical Society
Cobalt (Co) is a promising candidate to replace noble metals in the hydrogenation process, which is widely employed in the chemical industry. Although the catalytic performance for this reaction has been considered to be significantly dependent on the Co crystal phase, no satisfactory systematic studies have been conducted, because it is difficult to synthesize metal nanoparticles that have different crystalline structures with similar sizes. Here we report a new method for the synthesis of cobalt nanoparticles using hydrosilane as a reducing agent (hydrosilane-assisted method). This new method uses 1,3-butanediol and propylene glycol to successfully prepare fcc and hcp cobalt nanoparticles, respectively. These two types of Co nanoparticles have similar sizes and surface areas. The hcp Co nanoparticles exhibit higher catalytic performance than fcc nanoparticles for the hydrogenation of benzonitrile under mild conditions. The present hcp Co catalyst is also effective for highly selective benzyl amine production from benzonitrile without ammonia addition, whereas many catalytic systems require ammonia addition for selective benzyl amine production. Mechanistic studies revealed that the fast formation of the primary amine and the prevention of condensation and secondary amine hydrogenation promote selective benzonitrile hydrogenation for benzylamine over hcp Co nanoparticles.