1 August 2017 in Acta Astronautica
MDMayara K. da Silva Duarte
Mayara K. da Silva Duarte
1 January 2012 in Journal of Aerospace Technology and Management
WFWaldemar de Castro Leite Filho
Waldemar de Castro Leite Filho
The Journal of Aerospace Technology and Management is a techno-scientific publication serialized, edited, and published by the Institute of Aeronautics and Space (Instituto de Aeron
21 November 2013 in Mathematical Problems in Engineering
IFIjar Milagre da Fonseca
The aim of this paper is to present a fault detection algorithm (FDI) based on signal processing techniques developed for an inertial measurement unit (IMU) with minimal redundancy of fiber optic gyros. In this work the recursive median filter is applied in order to remove impulses (outliers) arising from data acquisition process and parity vector operations, improving the fault detection and isolation performance. The FDI algorithm is divided into two blocks: fault detection (FD) and fault isolation (FI). The FD part of the algorithm is used to guarantee the reliability of the isolation part and is based on parity vector analysis using -CUSUM algorithm. The FI part is performed using parity space projection of the energy subbands obtained from wavelet packet decomposition. This projection is an extension of clustering analysis based on singular value decomposition (SVD) and principal component analysis (PCA). The results of the FD and FI algorithms have shown the effectiveness of the proposed method, in which the FD algorithm is capable of indicating the low-level step bias fault with short delay and a high index of correct decisions of the FI algorithm also with low-level step bias fault.
1 January 2012 in Mathematical Problems in Engineering
The problem of fault detection and isolation (FDI) on inertial measurement units (IMUs) has received great attention in the last years, mainly with growing use of IMU strapdown platforms using fiber optic gyros (FOG) or micro electro mechanical systems (MEMSs). A way to solve this problem makes use of sensor redundancy and parity vector (PV) analysis. However, the actual sensor outputs can include some anomalies, as impulsive noise which can be associated with the sensors itself or data acquisition process, committing the elementary threshold criteria as commonly used. Therefore, to overcome this problem, in this work, it is proposed an algorithm based on median filter (MF) for prefiltering and chi‐square cumulative sum (χ2‐CUSUM) only for fault detection (FD) applied to an IMU composed by four FOGs.
16 May 2021 in International Journal of Satellite Communications and Networking
This paper presents the validation of a software‐defined baseband (SDB) system for satellite telemetry and telecommand (TM/TC). The baseband system was developed using the open‐source GNU Radio development kit. It runs on a personal computer connected to a commercial‐off‐the‐shelf (CoTS) RF frontend. The validation process was performed by the use of a mission‐qualified satellite emulator, a state‐of‐the‐art baseband unit, and orbiting satellites. The baseband is designed to offer multimission support. Hence, it includes a suite of modulation schemes, line codes, matched filters, and Consultative Committee for Space Data Systems (CCSDS) forward error correction codes (convolutional, Reed–Solomon, concatenated, and low‐density parity‐check [LDPC]) typically employed in TM/TC missions. The figures of merit used for the validation of the TM receiver are bit error rate (BER) and frame error rate (FER). For the TC transmitter, the validated features are modulation index, power spectrum, and the physical layer operations procedures (PLOP). Graphical Abstract We present the validation of a software‐defined baseband system for satellite ground operations. Based on low‐cost software‐defined radios, the baseband show minimal performance degradation in a laboratory environement. Infield tests shows that the baseband is capable of supporting ground operations for orbiting satellites.