We report a robust and high-yield fabrication method for wafer-scale patterning of high-quality arrays of dense gold nanogaps, combining displacement Talbot lithography based shrink-etching with dry etching, wet etching, and thin film deposition techniques. By using the self-sharpening of -oriented silicon crystal planes during the wet etching process, silicon structures with extremely smooth nanogaps are obtained. Subsequent conformal deposition of a silicon nitride layer and a gold layer results in dense arrays of narrow gold nanogaps. Using this method, we successfully fabricate high-quality Au nanogaps down to 10 nm over full wafer areas. Moreover, the gap spacing can be tuned by changing the thickness of deposited Au layers. Since the roughness of the template is minimized by the crystallographic etching of silicon, the roughness of the gold nanogaps depends almost exclusively on the roughness of the sputtered gold layers. Additionally, our fabricated Au nanogaps show a significant enhancement of surface-enhanced Raman scattering (SERS) signals of benzenethiol molecules chemisorbed on the structure surface, at an average enhancement factor up to 1.5 × 106.
Raman-based sensors represent a promising solution to enable both detection and fingerprinting of anionic pollutants in the water distribution network. Due to the weak nature of Raman scattering, a signal intensity enhancement mechanism, such as surface enhanced Raman spectroscopy (SERS), is required. Given the combination of SERS being a first layer effect and the low affinity for metallic surfaces shown by anions, functionalization of the SERS substrates using positively charged self-assembled monolayers (SAMs) is required to guarantee a strong SERS signal. In this work, the performance of three thiol-based coatings, namely, 2-mercapto-4-methyl-pyrimidine, cysteamine, and 2-dimethyl-amino-ethanethiol, is systematically compared for the detection of nitrite, nitrate, and perchlorate ions in water. For each coating, the limit of detection of those analytes is studied in combination with commercial SERS substrates. Cysteamine-coated SERS substrates are shown to provide the lowest limit of detection for the three analytes of this study. Evaluation of this coating on real drinking water samples is reported.
Waveguide Raman spectroscopy uses the evanescent field outside a waveguide to probe the analyte on the surface of the chip, permitting to selectively study thin films or nanostructures on top of the waveguide while benefiting from the long iteration path of the excitation with the analyte. Both the polarization of the excitation mode as well as the refractive index contrast of the waveguide platform play an important role in the Raman excitation process as well as the coupling efficiency of the generated Raman signal back into the waveguide. In this article, we characterize three waveguide platforms of different refractive index contrasts for waveguide Raman, namely Al2O3, Si3N4 and TiO2 on SiO2. Toluene was used as a test analyte. Both background and analyte were measured for quasi- transverse electric (quasi-TE) and quasi- transverse magnetic (quasi-TM) modes. TM modes generate less background than TE modes due to less confinement of the mode in the waveguide core materials. A combination of Si3N4 and quasi-TM polarization led to the highest SNR in this study.