1 July 1996 in Applied Physics Letters
Lattice parameters of gallium nitride were measured using high-resolution x-ray diffraction. The following samples were examined: (i) single crystals grown at pressure of about 15 kbar, (ii) homoepitaxial layers, (iii) heteroepitaxial layers (wurtzite structure) on silicon carbide, on sapphire, and on gallium arsenide, (iv) cubic gallium nitride layers on gallium arsenide. The differences between the samples are discussed in terms of their concentrations of free electrons and structural defects.
9 October 1995 in Applied Physics Letters
We investigated the pressure behavior of yellow luminescence in bulk crystals and epitaxial layers of GaN. This photoluminescence band exhibits a blueshift of 30±2 meV/GPa for pressures up to about 20 GPa. For higher pressure we observe the saturation of the position of this luminescence. Both effects are consistent with the mechanism of yellow luminescence caused by electron recombination between the shallow donor (or conduction band) and a deep gap state of donor or acceptor character.
1 October 2003 in Solid State Communications
30 September 2019 in Applied Physics Letters
A high activation ratio of acceptors to Mg ions implanted into a homoepitaxial GaN layer was achieved through an ultra-high-pressure annealing (UHPA) process. Capless annealing under a nitrogen pressure of 1 GPa in a temperature range of 1573–1753 K activated acceptors without thermally decomposing the GaN layer. Conventional rapid thermal annealing leads to a serious decomposition at 1573 K, even with an AlN protective cap. The sample annealed at 1673 K under UHPA exhibited very intense cathodoluminescence in near-band edge and donor-acceptor-pair band emissions. The intensities were over one order of magnitude higher than those of the sample treated by conventional annealing. A Hall-effect measurement was obtained in the temperature range of 275–500 K for the UHPA sample. The obtained hole concentration and mobility at 300 K were 3.6 × 1016 cm−3 and 24.1 cm2 V−1 s−1, respectively. The mobility value was close to that of an epitaxial p-type GaN with the same doping concentration. An Arrhenius plot of hole concentrations showed that the acceptor concentration and ionization energy were separately estimated to be (2.6 0.8) × 1018 cm−3 and 212 5 meV, respectively. By comparing the Mg concentrations obtained from secondary ion mass spectrometry, the acceptor activation ratio (acceptor concentration/Mg concentration) of the UHPA samples exceeded 70%. These results suggest that the UHPA process as a postimplantation annealing technique is promising for the fabrication of GaN-based power devices with selective area doping.
30 June 2017 in Chemistry of Materials
1 June 2016 in Journal of Non-Crystalline Solids