Juefei Yang

Juefei Yang

Auto-generated profile, based on publicly available information

Juefei Yang

Department of Electrical Engineering, University of Bristol, Bristol, U.K.

Research Focus & Metrics

Academic Career Length

24Years (2003-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 June 2023 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
RYRenze Yu
Renze Yu
SJSaeed Jahdi
Saeed Jahdi
PMPhil Mellor
Phil Mellor
LLLi Liu
Li Liu
JYJuefei Yang
Juefei Yang
JGJose Ortiz Gonzalez
Jose Ortiz Gonzalez
In this article, the reliability of planar, symmetrical, and asymmetrical trench SiC mosfet s is analysed under repetitive short circuit impulses at 300 and 450 K. Both static and dynamic parameters are measured to characterize the degradation pattern of the three mosfet structures. The degradation mechanisms are analyzed and the internal electro-thermal behavior of mosfet s is revealed through TCAD models. It has been found out that there is minor degradation for planar SiC devices under both test conditions. The symmetrical trench SiC mosfet has the lowest reliability, which fails after 200 and 80 cycles at room and elevated temperature. The asymmetrical trench SiC mosfet has slightly higher reliability, failing after 1500 cycles and 500 cycles at room and elevated temperature, respectively. A comprehensive range of measurements until failure and the corresponding Silvaco TCAD analysis confirms that for both trench SiC mosfet s, the deterioration of the gate oxide is responsible for the degradations and device failure. The higher the temperature, the higher electro-thermo-mechanical stress the devices suffer.

12 April 2021 in IEEE Open Journal of Power Electronics
Verified
Journal Article
Open access
JYJuefei Yang
Juefei Yang
SJSaeed Jahdi
Saeed Jahdi
BSBernard Stark
Bernard Stark
OAOlayiwola (Layi) Alatise
Olayiwola (Layi) Alatise
JGJose Ortiz Gonzalez
Jose Ortiz Gonzalez
PMPhil Mellor
Phil Mellor
In this paper, performance at 1 st and 3 rd quadrant operation of Silicon and Silicon Carbide (SiC) symmetrical and asymmetrical double-trench, superjunction and planar power MOSFETs is analysed through a wide range of experimental measurements using compact modeling. The devices are evaluated on a high voltage clamped inductive switching test rig and switched at a range of switching rates at elevated junction temperatures. It is shown, experimentally, that in the 1 st quadrant, CoolSiC (SiC asymmetrical double-trench) MOSFET and SiC symmetrical double-trench MOSFET demonstrate more stable temperature coefficients. Silicon Superjunction MOSFETs exhibits the lowest turn-off switching rates due to the large input capacitance. The evaluated SiC Planar MOSFET also performs sub-optimally at turn-on switching due to its higher input capacitance and shows more temperature sensitivity due to its lower threshold voltage. In the 3 rd quadrant, the relatively larger reverse recovery charge of Silicon Superjunction MOSFET negatively impacts the turn-OFF transients compared with the SiC MOSFETs. It is also seen that among the SiC MOSFETs, the two double-trench MOSFET structures outperform the selected SiC planar MOSFET in terms of reverse recovery.

22 March 2022 in IEEE Open Journal of the Industrial Electronics Society
Verified
Journal Article
Open access
JYJuefei Yang
Juefei Yang
SJSaeed Jahdi
Saeed Jahdi
BSBernard Stark
Bernard Stark
OAOlayiwola (Layi) Alatise
Olayiwola (Layi) Alatise
JGJose Ortiz Gonzalez
Jose Ortiz Gonzalez
PMPhil Mellor
Phil Mellor
In this paper, the crosstalk-induced shoot-through current and induced gate voltage of SiC planar MOSFETs, SiC symmetrical double-trench MOSFETs and SiC asymmetrical double-trench MOSFETs is investigated on a half-bridge circuit to analyse the impact of temperature, drain-source voltage switching rate, gate resistance and load current level on crosstalk-induced properties of different SiC MOSFET structures. It shows that due to the smaller gate-source capacitance, the two double-trench MOSFETs exhibit higher induced gate voltage during crosstalk with the same external gate resistance, which together with the higher transconductance, yield higher shoot-through current than the planar MOSFET. Accordingly, their shoot-through current decreases with increasing of the load current while the planar MOSFET exhibits an opposite trend. The different trend of shoot-through current with temperature on DUTs reveals that the crosstalk in different device structures are dominated by different mechanisms, i.e. threshold voltage and channel mobility with the gate-source capacitance influencing the amplitude. Impact of bias temperature instability with positive and negative gate stressing is measured with a range of stress and recover periods at temperateness ranging between 25 °C to 175 °C. These measurements show that the peak shoot-through correlates with the threshold drift, though with less sensitivity for SiC symmetrical and asymmetrical double-trench MOSFETs compared with the planar SiC MOSFET where the inter-dependence is pronounced. A model is developed for the induced gate voltage and shoot-through current during crosstalk with channel current considered. The comparison of the model results with measurement confirms its capability to predict crosstalk in different MOSFET structures.

19 January 2022 in IEEE Open Journal of the Industrial Electronics Society
Verified
Journal Article
Open access
CSChengjun Shen
Chengjun Shen
SJSaeed Jahdi
Saeed Jahdi
JYJuefei Yang
Juefei Yang
OAOlayiwola (Layi) Alatise
Olayiwola (Layi) Alatise
JGJose Ortiz Gonzalez
Jose Ortiz Gonzalez
PMPhil Mellor
Phil Mellor
The 4H-SiC vertical NPN BJTs are attractive power devices with potentials to be used as high power switching devices with high voltage ratings in range of 1.7 kV and high operating temperatures. In this paper, the advantages of the 4H-SiC NPN BJTs in terms of switching transients and current gain over their silicon counterparts is illustrated by means of extensive experimental measurements and modelling, including investigation of high level injection, as a common phenomenon in bipolar devices that influences the switching rates and DC current gain. The two device types have been tested at 800 V with maximum temperature of 175 °C and maximum collector current of 8 A. The turn-ON and turn-OFF transition in Silicon BJT is seen to be much slower than that of the SiC BJT while the transient duration will increase with increasing temperature and decreases with larger collector currents. The common-emitter current gain of SiC BJT is also found to be much higher than silicon counterparts, increasing with temperature in low injection levels but decreasing in higher injection levels in both devices. The rate of increase of current gain slows down toward stability as the collector current increases, known as the high-level injection. Current sharing imbalance among parallel connected devices is also investigated, which are shown to be evidently dependant on temperature and base resistance in Silicon BJT, while the current collapse in also seen in SiC BJT at high injection levels with high base resistance. The turn-OFF delay is seen to be temperature dependant in single and paralleled Silicon BJTs while almost non-existent in SiC device.

23 October 2023 in IEEE Open Journal of Power Electronics
Verified
Journal Article
Open access
JYJuefei Yang
Juefei Yang
SJSaeed Jahdi
Saeed Jahdi
RYRenze Yu
Renze Yu
BSBernard Stark
Bernard Stark
While SiC MOSFETs are now being utilized in industry their robustness under heavy-duty applications still remains a concern. In this paper, the results of experimental measurements of degradation to failure of different structured SiC power MOSFETs, namely the planar, symmetrical double-trench and asymmetrical trench structures are presented following electrothermal stressing by power cycling to beyond the safe operating area (SOA) limits. The tests are categorised in to subsets with/without forced cooling. The first set of tests involve successive switchings of the devices under constant DC current supply while their case temperature is monitored in real-time to evaluate their thermal performance. The symmetrical double-trench and asymmetrical trench MOSFETs are found to experience a higher case temperature rise thus prone to breakdown while failure is not observed in the planar structured device. The second experiment stresses the devices during continuous power cyclings with force cooling applied, in which the symmetrical and asymmetrical double-trench MOSFETs still encounter failure with detectable breakdown on the gate oxides, compared with the planar device which only exhibits degradation, without failure, with indications of aging.

25 June 2003
Verified
Conference Paper
Closed access
RYR. Yarborough
R. Yarborough
BLB. Landini
B. Landini
RWR. Welser
R. Welser
JYJ. Yang
J. Yang
THT. Henderson
T. Henderson