12 January 2015 in Applied Physics Letters
DC electrical conductivity, Seebeck and Hall coefficients are measured between 300 and 450 K on single crystals of monoclinic bismuth vanadate that are doped n-type with 0.3% tungsten donors (W:BiVO4). Strongly activated small-polaron hopping is implied by the activation energies of the Arrhenius conductivities (about 300 meV) greatly exceeding the energies characterizing the falls of the Seebeck coefficients' magnitudes with increasing temperature (about 50 meV). Small-polaron hopping is further evidenced by the measured Hall mobility in the ab-plane (10−1 cm2 V−1 s−1 at 300 K) being larger and much less strongly activated than the deduced drift mobility (about 5 × 10−5 cm2 V−1 s−1 at 300 K). The conductivity and n-type Seebeck coefficient is found to be anisotropic with the conductivity larger and the Seebeck coefficient's magnitude smaller and less temperature dependent for motion within the ab-plane than that in the c-direction. These anisotropies are addressed by considering highly anisotropic next-nearest-neighbor (≈5 Å) transfers in addition to the somewhat shorter (≈4 Å), nearly isotropic nearest-neighbor transfers.
9 November 2015 in MRS Bulletin
White Paper: High-temperature FORC study of single- and multi-phase permanent magnets - Volume 40 Issue 11 - Brad C. Dodrill, Jeffrey R. Lindemuth, Cosmin Radu, Harry S. Reichard
28 February 2002 in Japanese Journal of Applied Physics
Single magnetic field Hall measurements are inadequate for characterizing multicarrier mixed conduction in heterostructure devices, since the resultant mobility and density parameters are averaged over all carriers. We demonstrate an optimized quantitative mobility spectrum analysis (QMSA) technique for resolving individual carrier mobilities and densities in multi-carrier devices such as pHEMTs from field dependent Hall measurement data. The reliability and sensitivity of this technique suggests that it is a suitable standard tool for routine characterization of multi-carrier semiconductor devices.
1 December 2024 in Review of Scientific Instruments
Lock-in amplifiers are instrumental in the precise measurement of extremely small AC signals within high-noise environments. Traditionally, noise reduction in these instruments relies on infinite impulse response (IIR) filters, which can necessitate prolonged settling times to ensure the acquisition of accurate, statistically independent data. While moving average filters offer faster settling times, their non-monotonic frequency response may not be optimal for noise reduction. Conversely, IIR filters frequently realized as N-pole RC filters exhibit a monotonic frequency response conducive to effective noise reduction. This study presents a hybrid filter architecture that combines a short IIR filter with a longer moving average finite impulse response filter. The objective is to enhance noise reduction as quantified by the filter’s equivalent noise bandwidth (ENBW). Theoretical analysis is provided to derive the step response, settling time, frequency response, and ENBW of the hybrid filter configuration. Design methodologies are outlined for hybrid filters that either match the settling time of an N-pole RC filter while achieving a lower ENBW or maintain the ENBW of an N-pole RC filter but with significantly faster settling time. The performance of the hybrid filter is validated through noise measurements of low-value resistors and thermal noise of larger resistors, with results compared to theoretical predictions.