13 February 2017 in Journal of Geophysical Research: Solid Earth
There is wide concern that fluid injection in the subsurface, such as for the stimulation of shale reservoirs or for geological CO2 sequestration (GCS), has the potential to induce seismicity that may change reservoir permeability due to fault slip. However, the impact of induced seismicity on fracture permeability evolution remains unclear due to the spectrum of modes of fault reactivation (e.g., stable versus unstable). As seismicity is controlled by the frictional response of fractures, we explore friction‐stability‐permeability relationships through the concurrent measurement of frictional and hydraulic properties of artificial fractures in Green River shale (GRS) and Opalinus shale (OPS). We observe that carbonate‐rich GRS shows higher frictional strength but weak neutral frictional stability. The GRS fracture permeability declines during shearing while an increased sliding velocity reduces the rate of permeability decline. By comparison, the phyllosilicate‐rich OPS has lower friction and strong stability while the fracture permeability is reduced due to the swelling behavior that dominates over the shearing induced permeability reduction. Hence, we conclude that the friction‐stability‐permeability relationship of a fracture is largely controlled by mineral composition and that shale mineral compositions with strong frictional stability may be particularly subject to permanent permeability reduction during fluid infiltration.
12 June 2017 in Geophysical Research Letters
Hydraulic fracturing experiments were conducted at 200–450°C by injecting water into cylindrical granite samples containing a borehole at an initial effective confining pressure of 40 MPa. Intensive fracturing was observed at all temperatures, but the fracturing characteristics varied with temperature, perhaps due to differences in the water viscosity. At the lowest considered temperature (200°C), fewer fractures propagated linearly from the borehole, and the breakdown pressure was twice the confining pressure. However, these characteristics disappeared with increasing temperature; the fracture pattern shifted toward the formation of a greater number of shorter fractures over the entire body of the sample, and the breakdown pressure decreased greatly. Hydraulic fracturing significantly increased the permeability at all temperatures, and this permeability enhancement was likely to form a productive geothermal reservoir even at the highest considered temperature, which exceeded both the brittle‐ductile transition temperature of granite and the critical temperature of water.
7 December 2018 in Water Resources Research
The evolution of frictional strength, stability, and fracture permeability is intimately linked both to the seismic cycle and to the impact of hydraulic stimulation for fractured reservoirs. However, despite this importance, the poromechanical relationships between fault permeability and strength remain unclear. The present study explores this relationship via laboratory experiments for concurrent shear‐flow on smooth fractures of Westerly granite. The novelty of these experiments is that the shear velocity is precisely controlled during the measurement of fracture permeability. Results indicate permeability enhancement during velocity‐weakening (potentially unstable) frictional slip. To decipher key processes contributing to this response, we evaluate the state of contacting asperities and of fracture surface asperities via digital rock fracture modeling of statistically equivalent surfaces. We propose two plausible mechanisms constraining the relationship between friction and permeability evolution—one based on changes in asperity contact distribution and one on shear‐induced dilation triggered by changes in fault slip velocity. These mechanisms should be taken into account in interpreting field observation such as the abrupt permeability increase of natural faults at the onset of seismic slip.
5 November 2018 in Journal of Geophysical Research: Solid Earth
Roughness is widely observed on natural fractures, and its impact on the potential for induced seismicity and associated fluid migration in the subsurface remains unclear. Here we perform fracture shearing and fluid flow experiments on artificially fabricated fractures with specified roughness to investigate the role of fracture roughness on frictional properties and permeability evolution. Given the experimental conditions, we observe that rough fractures show high roughness ratio Sq/Lw and return higher frictional strength due to the presence of cohesive interlocking asperities. Rough fracture surfaces show velocity strengthening behavior in the initial shearing stage, which may evolve to velocity neutral and velocity weakening at greater displacements—suggesting a dynamic weakening that rough fractures become less stable with shearing. The surface roughness exerts a dominant control on permeability evolution over the entire shearing history. Permeability declines monotonically by about 2 orders of magnitude for smooth fractures. For high roughness fractures, the permeabilities evolve episodically due to cycled compaction and dilation during shearing. With a slip distance of 6 to 8 mm, permeability of the rough surface may enhance up to an order of magnitude, but significant permeability reduction may also occur for rough samples when asperities are highly worn with gouge clogging flow paths. However, there is no obvious correlation between permeability evolution and frictional behavior for rough fracture samples when fractures are subject to sudden sliding velocity changes.
1 February 2020 in Applied Energy
11 July 2016 in Geophysical Research Letters
Despite its importance, the relation between microearthquakes (MEQs) and changes in hydraulic properties during hydraulic stimulation of a fractured reservoir has rarely been explored, and it is still not well understood. To investigate this relation, we first formulate a plausible scale dependence, where fracture length and shear displacement are variables, for channeling flow through heterogeneous aperture distributions for joints and faults. By combining this formulation with the concept of the seismic moment, we derive quantitative relations between the moment magnitude (Mw) of MEQs and the fracture permeability change in the directions orthogonal to (kfault,⊥/kjoint) and parallel to (kfault,∥/kjoint) the shear displacement, in the form and . Despite the simplicity of the derivation, these relations have the potential to explain the results of field experiments on hydraulic stimulation, such as the enhanced geothermal systems at Soultz‐sous‐Fôret and Basel.