Yi Fang

Yi Fang

Auto-generated profile, based on publicly available information

Yi Fang

Institute for Geophysics Jackson School of Geosciences The University of Texas at Austin Austin TX USA

Research Focus & Metrics

Academic Career Length

31Years (1996-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 June 2018 in Journal of Petroleum Science and Engineering
Verified
Journal Article
Closed access
YJYunzhong Jia
Yunzhong Jia
YLYiyu Lu
Yiyu Lu
Dereck ElsworthDereck Elsworth
Dereck Elsworth
YFYi Fang
Yi Fang
JTJiren Tang
Jiren Tang

13 February 2017 in Journal of Geophysical Research: Solid Earth
Verified
Journal Article
Open access
PDF file
YFYi Fang
Yi Fang
Dereck ElsworthDereck Elsworth
Dereck Elsworth
CWChaoyi Wang
Chaoyi Wang
TITakuya Ishibashi
Takuya Ishibashi
JFJeffrey P. Fitts
Jeffrey P. Fitts
There is wide concern that fluid injection in the subsurface, such as for the stimulation of shale reservoirs or for geological CO2 sequestration (GCS), has the potential to induce seismicity that may change reservoir permeability due to fault slip. However, the impact of induced seismicity on fracture permeability evolution remains unclear due to the spectrum of modes of fault reactivation (e.g., stable versus unstable). As seismicity is controlled by the frictional response of fractures, we explore friction‐stability‐permeability relationships through the concurrent measurement of frictional and hydraulic properties of artificial fractures in Green River shale (GRS) and Opalinus shale (OPS). We observe that carbonate‐rich GRS shows higher frictional strength but weak neutral frictional stability. The GRS fracture permeability declines during shearing while an increased sliding velocity reduces the rate of permeability decline. By comparison, the phyllosilicate‐rich OPS has lower friction and strong stability while the fracture permeability is reduced due to the swelling behavior that dominates over the shearing induced permeability reduction. Hence, we conclude that the friction‐stability‐permeability relationship of a fracture is largely controlled by mineral composition and that shale mineral compositions with strong frictional stability may be particularly subject to permanent permeability reduction during fluid infiltration.

7 December 2018 in Water Resources Research
Verified
Journal Article
Open access
PDF file
TITakuya Ishibashi
Takuya Ishibashi
Dereck ElsworthDereck Elsworth
Dereck Elsworth
YFYi Fang
Yi Fang
JRJacques Riviere
Jacques Riviere
BMBenjamin Madara
Benjamin Madara
CMChris Marone
Chris Marone
The evolution of frictional strength, stability, and fracture permeability is intimately linked both to the seismic cycle and to the impact of hydraulic stimulation for fractured reservoirs. However, despite this importance, the poromechanical relationships between fault permeability and strength remain unclear. The present study explores this relationship via laboratory experiments for concurrent shear‐flow on smooth fractures of Westerly granite. The novelty of these experiments is that the shear velocity is precisely controlled during the measurement of fracture permeability. Results indicate permeability enhancement during velocity‐weakening (potentially unstable) frictional slip. To decipher key processes contributing to this response, we evaluate the state of contacting asperities and of fracture surface asperities via digital rock fracture modeling of statistically equivalent surfaces. We propose two plausible mechanisms constraining the relationship between friction and permeability evolution—one based on changes in asperity contact distribution and one on shear‐induced dilation triggered by changes in fault slip velocity. These mechanisms should be taken into account in interpreting field observation such as the abrupt permeability increase of natural faults at the onset of seismic slip.

5 November 2018 in Journal of Geophysical Research: Solid Earth
Verified
Journal Article
Open access
PDF file
YFYi Fang
Yi Fang
Dereck ElsworthDereck Elsworth
Dereck Elsworth
TITakuya Ishibashi
Takuya Ishibashi
Fengshou ZhangFengshou Zhang
Fengshou Zhang
Roughness is widely observed on natural fractures, and its impact on the potential for induced seismicity and associated fluid migration in the subsurface remains unclear. Here we perform fracture shearing and fluid flow experiments on artificially fabricated fractures with specified roughness to investigate the role of fracture roughness on frictional properties and permeability evolution. Given the experimental conditions, we observe that rough fractures show high roughness ratio Sq/Lw and return higher frictional strength due to the presence of cohesive interlocking asperities. Rough fracture surfaces show velocity strengthening behavior in the initial shearing stage, which may evolve to velocity neutral and velocity weakening at greater displacements—suggesting a dynamic weakening that rough fractures become less stable with shearing. The surface roughness exerts a dominant control on permeability evolution over the entire shearing history. Permeability declines monotonically by about 2 orders of magnitude for smooth fractures. For high roughness fractures, the permeabilities evolve episodically due to cycled compaction and dilation during shearing. With a slip distance of 6 to 8 mm, permeability of the rough surface may enhance up to an order of magnitude, but significant permeability reduction may also occur for rough samples when asperities are highly worn with gouge clogging flow paths. However, there is no obvious correlation between permeability evolution and frictional behavior for rough fracture samples when fractures are subject to sudden sliding velocity changes.

12 January 2018 in Geophysical Research Letters
Verified
Journal Article
Open access
PDF file
KIKyungjae Im
Kyungjae Im
Dereck ElsworthDereck Elsworth
Dereck Elsworth
YFYi Fang
Yi Fang
The evolution of permeability on fractures and faults during the full earthquake cycle is shown to be sensitive to sealing during the repose phase. We explore the combined effect of static loading followed by fracture reactivation on permeability evolution via slide-hold-slide experiments. During the hold periods, permeability exhibits a slow but continuous reduction. The permeability decay is consistent with power law compaction of the aperture coupled with cubic law flow. With increasing hold periods, permeability evolves following reactivation from net reduction to net increase with the magnitude of the permeability change dependent on the hold period. This implies that the tight interlocking of asperities during inter-seismic repose primes the fault for permeability enhancement following reactivation. The inferred mechanism is via shear dilation with the probable involvement of unclogging. This result identifies that pre-slip sealing during repose is an essential component in the cyclic permeability evolution throughout the seismic cycle.

19 May 2018 in Journal of Geophysical Research: Solid Earth
Verified
Journal Article
Open access
PDF file
YFYi Fang
Yi Fang
Dereck ElsworthDereck Elsworth
Dereck Elsworth
CWChaoyi Wang
Chaoyi Wang
YJYunzhong Jia
Yunzhong Jia
Massive fluid injection into the subsurface can induce microearthquakes by reactivating preexisting faults or fractures as seismic or aseismic slip. Such seismic or aseismic shear deformations may result in different modes of permeability evolution. Previous experimental studies have explored frictional stability‐permeability relationships of carbonate‐rich and phyllosilicate‐rich samples under shear, suggesting that friction‐permeability relationship may be primarily controlled by fracture minerals. We examine this relationship and identify the role of mineralogy (i.e., tectosilicate, carbonate, and phyllosilicate content) using direct‐shear experiments on smooth saw‐cut fractures of natural rocks and sintered fractures with distinct mineralogical compositions. These results indicate that the friction‐permeability relationship is controlled by mineralogy. Frictional strength and permeability change upon reactivation decrease with phyllosilicate content but increase with tectosilicate content. In contrast, the reverse trend is observed for frictional stability (a‐b). However, the permeability change decreases with carbonate content while both frictional strength and stability increase. The permeability change always decreases with an increase in frictional stability. This relationship implies a new mechanical‐hydro‐chemical coupling loop via a linkage of frictional properties, mineralogy, and permeability.