1 March 2025 in Physics of Fluids
This study investigates the flow characteristics and energy loss mechanisms in large vertical centrifugal pumps through entropy production theory and Q-criterion analysis, focusing on the effects of guide vane wrap angles and blade numbers. Numerical simulations reveal that optimal hydraulic performance occurs at a guide vane configuration of nine blades with a 48° wrap angle. Entropy production analysis demonstrates that turbulent entropy production and wall entropy production are dominant in the pumps, with the turbulent entropy production significantly exceeding the wall entropy production. The wrap angle significantly influences guide vane and volute performance, while showing limited impact on impeller efficiency. Increasing the wrap angle enhances flow control within the guide vane, reducing flow separation, and local turbulent entropy production. Conversely, reducing blade numbers induces flow channel blockage, increasing turbulence intensity in the downstream volute and elevating hydraulic losses in the guide vane, volute, and impeller under partial load conditions. Higher blade numbers improve flow rectification and enhance impeller–volute interaction, albeit at the cost of increased turbulent kinetic energy and frictional losses in the guide vane. These findings provide critical insight into flow-energy loss mechanisms and establish a theoretical foundation for optimizing guide vane structural design in large vertical centrifugal pumps, with potential applications in energy-efficient pump system development.
1 August 2025 in Physics of Fluids
An unsteady numerical calculation method was performed to investigate the hydraulic excitation suppression mechanism in volute centrifugal pumps with non-uniform inflow. The propagation characteristics of hydraulic excitation interaction, influence of non-uniform inflow, and rotor–stator interference were systematically analyzed. Results reveal that non-uniform inflow primarily originates from three dominant vertical structures: secondary flow vortices in the elbow inlet, baffle-separated vortices, and high-curvature side-separated vortices. By the way, non-uniform inflow exhibits three periodic pressure peaks within a single rotation cycle: the first from the reverse vortex disturbance of the secondary flow vortices in the elbow inlet pipe, the second from the rotor–stator interaction between the blade trailing edge and the volute tongue; and the third from the flow separation induced by the high-curvature side-separated vortices in the elbow inlet pipe. By adjusting the elbow inlet deflection angle to modulate phase differences between adjacent pressure peaks, mutual energy cancelation was achieved, notably filling the first pressure valley with the second peak. This phase modulation reduced the maximum amplitude of the second peak by up to 33%, effectively suppressing hydraulic excitation and enhancing flow stability. It provides valuable theoretical support for the design and application of centrifugal pumps with non-uniform inflow.