1 November 2022 in IEEE Transactions on Instrumentation and Measurement
An atomic clock with excellent long-term stability is important for maintaining the Local Atomic Time (TA(k)). The 87 Rb atomic fountain clock has the potential to fulfill these characteristics. It is required to operate continuously, similar to commercial cesium beam clocks and hydrogen masers. This paper describes the design and preliminary operation results of an 87 Rb atomic fountain continuous clock ( 87 RFCC) developed at the National Time Service Center (NTSC) of the Chinese Academy of Sciences. We adopted some improved design aspects and suppressed Majorana effect and microwave leakage to enhance the clock’s stability. Its continuous operation has been improved owing to the advantages of the high-reliability optical system and servo high-resolution offset generator (HROG) algorithm. We presented an algorithm for the 5 MHz/1 PPS signal output of the 87 RFCC through the HROG. The 87 RFCC exhibited a frequency stability of 1.91×10 -13 τ -1/2 , reaching 4.7×10 -16 at 200000 s. We referenced the 1 PPS output signal to the UTC(NTSC) and obtained the relative phase fluctuation of the 87 RFCC, which was within ±1.75 ns for approximately 90 days. We estimated the preliminary drift of the 87 RFCC relative to the UTC(NTSC) for three different periods at 0.000019±0.00148 ns/d/d, 0.00119±0.00182 ns/d/d, and -0.00155±0.00060 ns/d/d and discussed the results. During the 90-day evaluation period, although the frequency of the 87 RFCC relative to the UTC(NTSC) had changed, it still exhibited a low drift compared to cesium beam clocks and hydrogen masers, which highlights its potential for excellent long-term stability. The 87 RFCC investigated here has the potential to improve the local time scale.
20 May 2024 in IEEE Photonics Journal
The modulation transfer spectroscopy (MTS) technique used to stabilize two different transition lines of rubidium, required for laser cooling of atoms, is investigated. The laser source is based on a 1560 nm semiconductor laser diode that is amplified by an erbium doped fiber amplifier (EDFA). The laser output is frequency doubled with a fiber coupled periodically poled Lithium Niobate (PPLN) crystal to 780 nm. To address the weak spectral features of repumping laser, a theoretical study is conducted followed by experimental verification. The 87Rb D2 line F = 1 → F' = 0 transition temperature-enhanced MTS signal is observed, which provides a choice to stabilize the repumping laser frquency on the F = 1 → F ' = 2 transition using frequency shifting with acousto-optic modulators (AOMs). Compared with the orignal MTS signal, this method is shown to be more stable and accurate for laser frequency locking. Laer frequency locking is realized by controlling the driving current of the seed laser using digital PID feedback. After locking, the laser linewidth is 35.36 kHz.
5 June 2026 in IEEE Transactions on Instrumentation and Measurement
The time-keeping 87Rb fountain clock (TKRFC) is a microwave atomic clock with superior long-term frequency stability. However, as the core component, the Ramsey microwave cavity introduces key limitations for future engineering applications, particularly in system complexity, production consistency, and temperature sensitivity. This paper presents a novel cavity design, offering a new approach to overcoming these challenges. The core innovations are as follows: (1) A structural design incorporating a copper shielding tube and an extended lower end-cap with a cut-off waveguide physically suppresses microwave leakage interference on the atoms. This ensures performance while reducing or even eliminating the need for traditional external microwave interference switches. (2) A fully welded packaging process is employed, providing a viable and standardized solution for both vacuum and microwave sealing. (3) The cavity is designed with a relatively low loaded quality factor (~3120) to minimize temperature-driven cavity pulling frequency shifts. Theoretical and simulation analyses indicate that the cavity exhibits the potential to contribute to a relative frequency stability of the clock output below 1.3 × 10-17. This work explores a potential technical route to address key bottlenecks in the cavity, aiming to facilitate the future engineering application of the clock.
1 January 2022 in Acta Physica Sinica
蓝宝石谐振体内的电磁场为回音壁模式时具有极低的介质损耗. 本文采用径向-轴向模式匹配法, 理论分析了蓝宝石谐振体内的场模式分布, 分析了谐振频率与谐振体几何尺寸的关系; 其次, 基于有限元分析仿真了蓝宝石圆柱体内场分布情况; 研制了三维转动位移台, 采用磁环/探针耦合的方式激发蓝宝石谐振体内的回音壁电磁场, 测量了谐振体表面的S参数, 由此确定了谐振体内的回音壁模式参数, 得到谐振器的无载Q值为94000. 利用该谐振体可制成低相位噪声的微波振荡器.