Low-density polymer foams pre-ionized by a well-controlled nanosecond pulse are excellent plasma targets to trigger direct laser acceleration (DLA) of electrons by sub-picosecond relativistic laser pulses. In this work, the influence of the nanosecond pulse on the DLA process is investigated. The density profile of plasma generated after irradiating foam with a nanosecond pulse was simulated with a two-dimensional hydrodynamic code, which takes into account the high aspect ratio of interaction and the microstructure of polymer foams. The obtained plasma density profile was used as input to the three-dimensional particle-in-cell code to simulate energy, angular distributions and charge carried by the directional fraction of DLA electrons. The modelling shows good agreement with the experiment and in general a weak dependence of the electron spectra on the plasma profiles, which contain a density up-ramp and a region of near-critical electron density. This explains the high DLA stability in pre-ionized foams, which is important for applications.
7 February 2024 in Matter and Radiation at Extremes
Directed x-rays produced in the interaction of sub-picosecond laser pulses of moderate relativistic intensity with plasma of near-critical density are investigated. Synchrotron-like (betatron) radiation occurs in the process of direct laser acceleration (DLA) of electrons in a relativistic laser channel when the electrons undergo transverse betatron oscillations in self-generated quasi-static electric and magnetic fields. In an experiment at the PHELIX laser system, high-current directed beams of DLA electrons with a mean energy ten times higher than the ponderomotive potential and maximum energy up to 100 MeV were measured at 1019 W/cm2 laser intensity. The spectrum of directed x-rays in the range of 5–60 keV was evaluated using two sets of Ross filters placed at 0° and 10° to the laser pulse propagation axis. The differential x-ray absorption method allowed for absolute measurements of the angular-dependent photon fluence. We report 1013 photons/sr with energies >5 keV measured at 0° to the laser axis and a brilliance of 1021 photons s−1 mm−2 mrad−2 (0.1%BW)−1. The angular distribution of the emission has an FWHM of 14°–16°. Thanks to the ultra-high photon fluence, point-like radiation source, and ultra-short emission time, DLA-based keV backlighters are promising for various applications in high-energy-density research with kilojoule petawatt-class laser facilities.
Ultrabright, well-collimated MeV bremsstrahlung radiation was generated through the interaction of high-current electron beams produced via direct laser acceleration (DLA) with a high- Z converter. The DLA mechanism was initiated by a 200 TW, subpicosecond PHELIX laser pulse at a moderately relativistic intensity of (1–2) × 10 19 W cm − 2 , delivering approximately 60 J of energy into preionized, overcritical-density foam targets. The electron spectrum measured along the laser axis exhibited an effective temperature of approximately 30 MeV and energies exceeding 100 MeV, with a total charge of about 300 nC for electrons with energies > 1.5 MeV (ponderomotive potential), while 100 nC of them is directed along the laser axis within a half-angle cone of 12 ∘ . The directed fraction of DLA electrons with energies exceeding 7.5 MeV carries a charge of 20 to 30 nC, corresponding to a flux up to 2 × 10 24 sr − 1 s − 1 . These high-current relativistic electron beams efficiently generate MeV x-rays, enabling the subsequent production of isotopes, positrons, and neutrons with exceptional yield and application potential. In laser shots employing overcritical-density foam targets placed in front of a high- Z converter, bremsstrahlung photons with energies up to 70 MeV were generated and analyzed via nuclear activation of tantalum and gold. The formation of the isotopes 174 Ta and 190 Au , whose photonuclear cross-section peaks at approximately 65 MeV, confirmed the presence of high-energy photons. In contrast, no activation was observed in control shots where the laser was directed onto the converter without foam, indicating that high-energy photon generation is intrinsically linked to the DLA process in the preionized foam targets. Autoradiographic measurements revealed a divergence of the bremsstrahlung beam of approximately 22 ∘ (half-angle) in the 14–21-MeV range. These diagnostics indicate an unprecedented photon flux of approximately 2 × 10 22 sr − 1 s − 1 , corresponding to about 10 11 photons per shot with energies exceeding 7.5 MeV. The conversion efficiency of focused laser energy to bremsstrahlung photons is greater than 1% (within the FWHM of x-ray beam and laser beam). More than 2 × 10 9 photoneutrons per shot were emitted isotropically, corresponding to a peak flux of 2 × 10 20 cm − 2 s − 1 ( 4 × 10 18 cm − 2 s − 1 J − 1 of laser energy on target). This approach demonstrates a robust and scalable method for generating ultraintense MeV photon beams at kilojoule, petawatt-class laser facilities operating at moderate relativistic intensities, with strong implications for high-energy-density physics and nuclear astrophysics research.
This work presents the results of a nuclear fission experiment with depleted uranium, driven by ultra-intense multi-MeV bremsstrahlung, generated by laser-accelerated electrons in a high-Z converter, which enables the production of radioisotopes on the picosecond timescale. The advanced plasma target made of pre-ionized low-density foam enabled effective electron acceleration to energies of up to 100 MeV at a laser intensity of 1019 W cm−2 and the generation of ultra-bright bremsstrahlung with an effective temperature of 11.8 MeV in the giant dipole resonance region, with a previously unattained high conversion efficiency of 1%–2%. A major hazard in high-power laser experiments is the presence of harmful radiation and its impact on sensitive detectors. A gas flow system was used to transport volatile fission products from the laser-target interaction point to remote detectors in under ten seconds. This spatial separation of the detectors from the point of laser-matter interaction significantly reduces background noise, the impact of harmful radiation, and enables the detection of signals from short-lived radioisotopes—the products of induced nuclear fission—with high sensitivity.
25 February 2026 in Matter and Radiation at Extremes
Long-lived hot and dense plasmas generated by ultra-intense laser beams are of critical importance for laser-driven nuclear physics, bright hard X-ray sources, and laboratory astrophysics. We report the experimental observation of plasmas with nanosecond-scale lifetimes, near-solid density, and keV-level temperatures, produced by irradiating periodic arrays of composite nanowires with ultra-high-contrast relativistically intense femtosecond laser pulses. Jet-like plasma structures extending up to 1 mm from the nanowire surface were observed, emitting K-shell radiation from He-like Ti20+ ions. High-resolution X-ray spectra have been analyzed using 3D particle-in-cell (PIC) simulations of the laser–plasma interaction combined with collisional–radiative modeling (FLYCHK). The results indicate that the jets consist of plasma with densities of 1020–1022 cm−3 and keV-scale temperatures, persisting for several nanoseconds. We attribute the formation of these jets to the generation of kilotesla-scale global magnetic fields during the laser interaction, as predicted by PIC simulations. These fields may drive long-timescale current instabilities that sustain magnetic fields of several hundred tesla, sufficient to confine hot, dense plasma over nanosecond durations.